Abstract:Total heat exchange ventilation systems are effective in achieving energy savings by reducing the ventilation load in buildings, while maintaining a certain amount of fresh outdoor air intake. As the system's elemental materials exchange both latent and sensible heat, hydrophilic chemical compounds may be exchanged simultaneously. Proper control of the exchange of hazardous chemicals and pollutants via these heat exchange elements is an important issue in the development of total heat exchange ventilation systems. In this respect, the development of a numerical model that facilitates repeated sensitivity analysis is important in the development of a new total heat exchanger that has high heat exchange efficiency and suppresses the exchange of polluting chemicals. This study proposes new hygrothermal and chemical compound transfer models for paper-based hydrous materials, which are the main components of total heat exchangers in indoor ventilation systems. Through a series of numerical analyses and experimental measurements, the prediction accuracy of the mathematical model was compared with experimental results for the gas transfer rate in hydrous materials and a building-sized total heat exchanger. The results demonstrated that an increase in water content in hydrous material has a significant impact on the permeability of water-soluble gases, with NH 3 and HCHO permeability coefficients increasing by factors of 250 and 20 respectively. Conversely, for low-solubility gases such as CO 2 , the permeability coefficient only slightly increased at low humidity and remained largely unaffected thereafter. These findings contribute to the advancement of more efficient and safer total heat exchange ventilation systems.

Performances Of Gas-Water Direct-Contact Heat Transfer

Flue gas-water direct-contact heat transfer performances

Heat transfer performance of direct-contact flue-gas condensation heat exchanger

Thermal calculation method for direct-contact flue-gas-water condensation heat exchangers

Experimental Study on Flow and Heat Transfer Performance of Condensing Gas-Fired Boiler

The Preference of Steam-water Two-phase Flow Direct Contact Pressure-lifting Heater

Direct Contact Heat Transfer for Gas- Fired Hot Water Boiler

STUDY ON HEAT TRANSFER CHARACTERISTICS OF FLUE GAS CONDENSATION IN NARROW GAP HEAT EXCHANGERS

Assessing the performance of a gas-water heat exchanger based on micro-heat pipe technology

Effect of Non-Condensation Gas on Heat Transfer of Direct Contact Condensation

Heat and Mass Transfer Characteristics of Simulated High Moisture Flue Gases

Investigation of a Heat Pipe Heat Exchanger Integrated with a Water Spray for the Heat Recovery from Boil Exhaust Gas

Experimental study on heat transfer characteristics of steam underwater direct-contact condensation

Mathematical Modeling of Gas-phase Mass Transfer in Hydrous Materials for a Total Heat Exchange Ventilator

Experimental Study on the Heat Transfer of Convection and Condensation between the Staggered Bank and the Low Temperature Transversal Flow Flue Gas

A New Phase Transition Heat Exchanger for Gas Water Heaters

Development of a Direct Contact Heat Exchanger for Energy and Water Recovery from Humid Flue Gas

Experimental Study of the Flow and Heat Transfer of a Gas–water Mixture Through a Packed Channel

Comparison of Performance Characteristics of Desiccant Coated Air-Water Heat Exchanger with Conventional Air-Water Heat Exchanger – Experimental and Analytical Investigation

Numerical Investigation on Heat and Mass Transfer of Slit Finned Tube Heat Exchanger with Humid Flue Gas

Gas-side Fouling, Erosion and Corrosion of Heat Exchangers for Middle/low Temperature Waste Heat Utilization: A Review on Simulation and Experiment