Abstract:This paper is concerned with the design of bracing systems for three-ribbed parabolic arch bridges against out-ofplane buckling. Typical bracing systems for the three-ribbed arch bridges include K-bracing system and X-bracing system as well as transverse bracing system. The buckling criterion of the braced funicular three-ribbed arch bridge is derived from an exact matrix stiffness method (MSM) with a 14 x 14 s-order element stiffness matrix of three-dimensional beam-column elements that allows for torsional and warping deformations. The lateral torsional buckling load and mode are given by the lowest eigenvalue and eigenvector associated with the assembled structural stability stiffness matrix. A comparison study between different bracing system configurations suggests that the three-ribbed arches with the integral K- or X-bracing system (a K/X-bracing across the three arch ribs) have lower lateral torsional buckling loads than their arch counterparts with the independent Kor X-bracing system (the adjacent arch ribs are connected by K/X-bracing respectively), because the latter ones could provide more restraint on the middle arch rib to avoid early lateral torsional instability. Further, a bracing utilization efficiency index (defined as the normalized buckling capacity over material usage for bracing system) is proposed to quantify the effect of bracing systems in improving the lateral torsional buckling capacity of arch bridges. Highly efficient bracing systems that maximize the lateral torsional buckling load of three-ribbed arch structures with the lowest bracing material usage are then recommended.

OUT-OF-PLANE BUCKLING ANALYSIS OF NON-SYMMETRIC CROSS-BRACING SYSTEMS OF TRANSMISSION TOWERS

Out-of-plane stability of simply supported beams with knee braces

Optimal Bracing System Design for Funicular Twin Arches Against Out-of-plane Buckling

Elastic Buckling of Inter-Braced Parallel Beam Systems

Buckling of Flexural-Shear Bracing System and Its Braced Steel Frames

A Simplified Method for the Buckling of Outrigger-Shear Wall Braced Structures

Analysis on Bearing Capacity of Rigid Frame Column when Horizontal Knee-braces at Ends of Crane Beams

BUCKLING OF TOP-OUTRIGGER BRACED FRAME-TUBE STRUCTURES AND THE AMPLIFICATION FACTORS FOR DISPLACEMENT AND MOMENT

Bracing Systems for Three-Ribbed Arch Bridges Against Out-of-plane Buckling

In-plane buckling analysis of the horsizontal spring circular arch under concentrated load at the mid-span

STABILITY OF DOUBLY SYMMETRIC I-SECTIONAL CANTILEVERS WITH DIFFERENT BOUNDARY CONDITIONS AT TIP

Computation of Local Bearing Stress in Web of Beams Supporting Overhead Cranes

EFFECTIVE LENGTH FACTOR OF ANGLES ALTERNATELY BRACED IN TWO LEGS

IN-PLANE ELASTIC BUCKLING OF STEEL CIRCULAR ARCHES WITH HORIZONTAL SPRING SUPPORT

Analytical Study On Buckling Restrained Braced Composite Frames

A simplified analysis on elastic plastic stability of flexural bracing-frame system

Determination of buckling mode for elastic-plastic braced frames

JOINTS OF MULTI-STORY SPANNED DIAGONAL BRACING SYSTEM IN TALL STEEL BUILDINGS: ANALYSIS AND DESIGN METHOD

Optimal Design of Crossbeam Stiffness Factor in Bridge Towers Using a Reliability-Based Approach

Buckling of laterally and torsionally braced beams

Effective Length Factor of a Non-Symmetrical Cross-Bracing System with a Discontinuous Diagonal