Abstract:Developing nonlinear structural models with high accuracy and affordable compu- ting cost is a challenging issue and one of the pressing needs in earthquake engineering. The paper presents a quadrature beam model for distributed plasticity seismic analysis of steel frames. It is based on the newly developed weak-form quadrature element method, in which the variation principle and the differential quadrature analog are combined. One quadrature beam element can simulate a beam-column member with varying cross-section and non- uniformly distributed loads. The formulations of tangent stiffness matrix and consistent mass matrix are derived. The section constitutive relation of a beam-column member is directly de- rived using fiber model and material properties. Inelastic time history analysis of the LA 3- story moment-resisting steel frame is conducted to demonstrate the accuracy and efficiency of the quadrature beam model. For verification and comparison, the frame is also analyzed us- ing ANSYS with its BEAM188 element and OpenSEES with the force-based beam element. It is shown that: a) by increasing the number of integration points in one element, results of the quadrature beam model are in excellent agreement with those computed by the displacement- based model in ANSYS; b) degrees of the freedom and the CPU time consumption of the quadrature beam model are much lower than those of the displacement-based model; c) the convergence rate of the quadrature beam model is comparable to that of the force-based model, and the time consumption of the quadrature beam model is slightly higher. In contrast to the only available lumped mass matrix of the force-based model, it is easy to acquire con- sistent mass matrix in the quadrature beam model for inelastic dynamic analysis, highlighting its great potentials in seismic analysis of frames.

DYNAMIC SPLINE WEIGHTED RESIDUAL METHOD FOR THE VERTICAL SEISMIC RESPONSES ANALYSES OF LATTICED FRAME

A new average response spectrum method for linear response analysis of structures to spatial earthquake ground motions

Experimental study and numerical simulation of seismic performance of stiffened thin steel plate shear walls considering the effect of vertical load on frame column

Stochastic Seismic Response Analysis of Long-span Continuous Rigid Frame Bridge

Linear‐elastic Lateral Load Analysis and Seismic Design of Pin‐supported Wall‐frame Structures with Yielding Dampers

Numerical Analysis on the Seismic Behavior of Frame Structure with Dry Stack Infilled Panel

Seismic response analysis of the frame-shear wall structure considering distributed mass

DYNAMIC INSTABILITY ANALYSIS OF SPATIAL FRAME

STUDIES ON THE ASEISMIC PERFORMANCE OF HIGH RISE STEEL STRUCTURES WITH NEW BEAM-COLUMN JOINTS DISSIPATING SEISMIC ENERGY

Development of a double-stage-yield dissipative beam-to-column joint: Experimental study and application for structural response control

Application of weighted residual method in whole internal force calculation of anti-slide pile

An efficient approach for the equivalent linearization of frame structures with plastic hinges under nonstationary seismic excitations

Displacement-based Design Method for Energy Dissipation Structures with Nonlinear Viscous Dampers

Seismic Analysis of a Frame-shear Wall Structure with Viscous Dampers

A modified scaled boundary finite element method for dynamic response of a discontinuous layered half-space

Identification of Multi-Axial Seismic Loadings from Several Structural Dynamic Responses

An Efficient Quadrature Beam Model to Simulate Inelastic Seismic Behavior of Steel Frames

Study on Displacement-Based Design Method for Energy Dissipation Structures

Damage Identification of Semi-Rigid Joints in Frame Structures Based on Additional Virtual Mass Method

Elasto-Plastic Seismic Shear Distributions of Frame-Wall Structures

Performance-based seismic design method for disc spring-based self-centering viscous dissipative braced steel frame