An Efficient Quadrature Beam Model to Simulate Inelastic Seismic Behavior of Steel Frames

R. He,R. Zhang,H. Zhong

DOI: https://doi.org/10.7712/compdyn-2011.0001

2011-01-01

Abstract:Developing nonlinear structural models with high accuracy and affordable compu- ting cost is a challenging issue and one of the pressing needs in earthquake engineering. The paper presents a quadrature beam model for distributed plasticity seismic analysis of steel frames. It is based on the newly developed weak-form quadrature element method, in which the variation principle and the differential quadrature analog are combined. One quadrature beam element can simulate a beam-column member with varying cross-section and non- uniformly distributed loads. The formulations of tangent stiffness matrix and consistent mass matrix are derived. The section constitutive relation of a beam-column member is directly de- rived using fiber model and material properties. Inelastic time history analysis of the LA 3- story moment-resisting steel frame is conducted to demonstrate the accuracy and efficiency of the quadrature beam model. For verification and comparison, the frame is also analyzed us- ing ANSYS with its BEAM188 element and OpenSEES with the force-based beam element. It is shown that: a) by increasing the number of integration points in one element, results of the quadrature beam model are in excellent agreement with those computed by the displacement- based model in ANSYS; b) degrees of the freedom and the CPU time consumption of the quadrature beam model are much lower than those of the displacement-based model; c) the convergence rate of the quadrature beam model is comparable to that of the force-based model, and the time consumption of the quadrature beam model is slightly higher. In contrast to the only available lumped mass matrix of the force-based model, it is easy to acquire con- sistent mass matrix in the quadrature beam model for inelastic dynamic analysis, highlighting its great potentials in seismic analysis of frames.