Abstract:Emissions of NO and Volatile Organic Compounds (VOCs) in China are growing rapidly, thus it is necessary to develop a catalyst that can simultaneously remove them. In this study, a series of new V-W/Ti SCR catalysts modified by Cu, Fe and Co were prepared by wet impregnation method, which was used to simultaneously remove NO and typical VOCs (benzene and toluene) from coal-fired power plant flue gas. The catalyst activity evaluation was studied in selective catalytic reduction temperature window (260 °C, 300 °C, 340 °C, 380 °C and 420 °C) by a self-built device. Simulated flue gas was composed of 100 ppm benzene, 100 ppm toluene, 500 ppm NO, 1000 ppm SO2, 500 ppm NH3, 3.33% O2, and balanced N2, whose total flow was 750 mL/min. Characterization techniques such as SEM-EDS, XRD, XPS, and NH3-TPD were used to analyze the effect of Cu, Fe and Co loading on the catalyst's surface properties, physical structure, valence, and acid site, which further explained the removal efficiency result. The experimental results indicated that Cu0.1-V-W/Ti had the best denitration performance at low temperature and reached a maximum NO removal rate of 86.4% at 340 °C. All prepared catalysts had over 90% benzene removal and over 95% toluene removal rate. Cu0.1-V-W/Ti shows certain SO2 tolerance and has the potential to be used for simultaneous removal of NO and VOCs at SCR area of coal-fired power plants without extra capital cost.

Deactivation of commercial SCR catalyst used in 1000MW coal-fired power plant

Deactivation and Regeneration of Commercial SCR Catalysts Used in a 660 MW Coal-Fired Power Plant

Deactivation mechanism and regeneration of SCR denitration catalyst served in biomass power plant

In Situ Treatment by High-Temperature Water Vapor As a Novel Health-Care Approach for Commercial SCR Catalyst

Insight into deactivation of commercial SCR catalyst by arsenic: an experiment and DFT study.

Deactivation Mechanism of Multipoisons in Cement Furnace Flue Gas on Selective Catalytic Reduction Catalysts

A Research on the Regeneration of Deactivated SCR Catalyst Used in Coal-Fired Plant

MECHANISM AND ANALYSIS OF SCR CATALYST DEACTIVATION

In Situ Regeneration of Commercial NH3-SCR Catalysts with High-Temperature Water Vapor

Review of the Deactivation of Selective Catalytic Reduction DeNOx Catalysts

Regeneration Of Commercial Scr Catalysts: Probing The Existing Forms Of Arsenic Oxide

A comprehensive review of deactivation and modification of selective catalytic reaction catalysts installed in cement kilns

Deactivation Influence of HF on the V 2 O 5 –WO 3 –TiO 2 SCR Catalyst

An analysis of SCR reactor deactivation impact on NOx emissions from a compression ignition engine

Chemical deactivation of Selective Catalytic Reduction catalyst: Investigating the influence and mechanism of SeO<sub>2</sub> poisoning

Performance Evaluation and Life Management of SCR Denitration Catalyst

Investigation of Arsenic Poisoned Selective Catalytic Reduction Catalyst Performance and Lifetime in Coal-Fired Power Plants

Performance of transition metal (Cu, Fe and Co) modified SCR catalysts for simultaneous removal of NO and volatile organic compounds (VOCs) from coal-fired power plant flue gas

Deactivation of CeO2-TiO2 catalyst by K2SO4 for NH3-SCR: An experimental and DFT study

Whole Life Cycle Performance Evolution of Selective Catalytic Reduction Catalyst in Coal-Fired Power Plants

Summary of deactivation mechanism for SCR denitration catalyst