Abstract:Supported V2O5–WO3/TiO2 materials are employed as selective catalytic reduction (SCR) catalysts for NOx emission control from power plants. Fresh SCR catalysts usually receive exposure to harsh treatments in the industry to accelerate catalyst activation (calcination in air at 650 °C) and catalyst aging (hydrothermal aging at 650 °C) in a way that represents various points in the catalyst/product lifetime. The present study investigates the catalyst structural and chemical changes occurring during such harsh treatments. Three series of supported V2O5–WO3/TiO2 catalysts were prepared by incipient-wetness impregnation of aqueous ammonium metavanadate and metatungstate precursors. The catalysts were subsequently dried and calcined at 550 °C in O2, 650 °C in O2, and hydrothermal conditions (10% O2, 8% H2O, 7% CO2, and 75% N2) at 650 °C. The resulting catalysts were physically characterized by numerous techniques (in situ Raman; in situ IR; in situ high-field–high-spinning solid-state 51V MAS NMR; in situ electron paramagnetic resonance; X-ray diffraction; Brunauer, Emmett, and Teller surface area; and inductively coupled plasma) and chemically probed with adsorbed ammonia, SCR–TPSR, and the SCR reaction. The surface WOx sites on the TiO2 support behave as a textural promoter that stabilizes the TiO2 (anatase) phase from sintering and transforming to the undesirable crystalline TiO2 (rutile) phase that can lead to formation of a Ti1–xVxO2 (rutile) solid solution with reduced V4+ cations (∼7–15%). The surface VOx sites are mostly oligomerized as surface V5+Ox sites (∼50–85% oligomers) and the extent of oligomerization tends to increase with surface WOx coverage and calcination temperature. A major difference between the calcined and hydrothermally treated catalysts was the low concentration of surface NH3* species on Lewis acid sites for the hydrothermally treated catalysts, yet the SCR activity was almost comparable for both catalysts. This finding suggests that surface NH4+*, primarily associated with the surface VOx sites, are able to efficiently perform the SCR reaction. Given that multiple catalyst parameters were simultaneously varying during these treatments, it was difficult to correlate the SCR activity with any single catalyst parameter. A correlation, however, was found between the SCR TOF/activity and the sum of the surface NH3* and NH4+* species, which is dominated by the surface NH4+* species.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acscatal.1c02130.ICP of vanadium content of catalysts; crystallite sizes for supported VWTi catalysts treated at 650 °C; EPR determination of V4+; solid-state 51V MAS NMR spectra of dehydrated supported V2O5–WO3/TiO2 catalysts calcined at 650 °C; EPR spectra of non-vanadium species; in situ TP-IR spectra of surface ammonia species during SCR; correlation plots between steady-state SCR TOF values and structural properties of VWTi catalysts; and radar plots of catalytic activity and catalyst properties (PDF)This article has not yet been cited by other publications.

In Situ Treatment by High-Temperature Water Vapor As a Novel Health-Care Approach for Commercial SCR Catalyst

In Situ Regeneration of Commercial NH3-SCR Catalysts with High-Temperature Water Vapor

Deactivation Mechanism and Feasible Regeneration Approaches for the Used Commercial NH3-SCR Catalysts

The deactivation of De-NOx SCR catalyst by combining alkali doping and thermal treatment

Deactivation and Regeneration of Commercial SCR Catalysts Used in a 660 MW Coal-Fired Power Plant

Catalytic Destruction of A Surrogate Organic Hazardous Air Pollutant As A Potential Co-Benefit for Coal-Fired Selective Catalytic Reduction Systems

Selective Catalytic Reduction of NOx with NH3 over Short-Range Ordered W-O-Fe Structures with High Thermal Stability

Deactivation of commercial SCR catalyst used in 1000MW coal-fired power plant

Effective regeneration of thermally deactivated commercial V-W-Ti catalysts

In situ DRIFTS FT-IR and DFT study on Fe-V-W/Ti removal of NOx and VOCs

The Regeneration Effect of H2SO4 on V-W-TiO2 SCR Catalyst Deactivated by Alkali Metal

Deactivation Influence of HF on the V2O5–WO3–TiO2 SCR Catalyst

Deactivation Influence of HF on the V 2 O 5 –WO 3 –TiO 2 SCR Catalyst

A Novel Method of Microwave Heating Mixed Liquid-Assisted Regeneration of V 2 O 5 –WO 3 /tio 2 Commercial SCR Catalysts

New Insight into SO2 Poisoning and Regeneration of CeO2-WO3/TiO2 and V2O5-WO3/TiO2 Catalysts for Low-Temperature NH3-SCR

Selective Catalytic Removal of High Concentrations of NOx at Low Temperature

Elimination of PCDD/Fs over Commercial Honeycomb-Like Catalyst of V<sub>2</sub>O<sub>5</sub>-MoO<sub>3</sub>/TiO<sub>2</sub> at Low Temperature: From Laboratory Experiments to Field Study

Performance of transition metal (Cu, Fe and Co) modified SCR catalysts for simultaneous removal of NO and volatile organic compounds (VOCs) from coal-fired power plant flue gas

Structure–Activity Relationships of Hydrothermally Aged Titania-Supported Vanadium–Tungsten Oxide Catalysts for SCR of NO x Emissions with NH 3

Deactivation mechanism of de-NOx catalyst (V2O5-WO3/TiO2) used in coal fired power plant

Hydrothermal Aging Treatment Activates V2O5/TiO2 Catalysts for NOx Abatement