Abstract:Active components reloading is critical process for the catalyst regeneration, which is limited by the low adsorption capacity and unwilling distribution of desired components to the catalyst surface. Herein we demonstrated that with dimethyl formamide(DMF) modification and sequentially reloading of vanadium, the traditional V-Ti SCR catalyst, which uses vanadium as the active components and titanium as the carrier, showed the significantly improved DeNOx performance, owing to the increased adsorption capacity and desired distribution of vanadium. When the DMF concentration was 6%, the adsorption capacity of the promoted catalyst was 3.58 and 6.57 mg/g under vanadyl ion concentrations of 1.5 and 3 g/L, respectively, 135 and 147% higher than that of the original catalyst. Adsorption kinetics demonstrated that the pseudo-second-order kinetic model better describes the process by which vanadyl ions adsorb onto the catalyst. In addition, the adsorption equilibrium indicated that Langmuir model was a closer fit for the vanadyl ion adsorption to the promoted catalyst. After DMF modification, the vanadyl ions were first adsorbed onto the functional groups on the catalyst surface, substantially increasing the vanadium loading on the catalyst surface while limiting the increase in vanadium content within the interior of catalyst, which was conducive to enhancing the DeNOx activity and reducing the increase in the SO2/SO3 conversion. When the vanadium adsorption capacity was 3.5 mg/g, the increase in the DeNOx activity of the promoted catalyst was 68.1% higher than that of the original catalyst, whereas the increase in SO2/SO3 conversion was 28.9% lower than that of the original catalyst. Thus, in the regeneration of SCR catalysts vanadium initial concentration and loading could be reduced.

A Novel Method of Microwave Heating Mixed Liquid-Assisted Regeneration of V 2 O 5 –WO 3 /tio 2 Commercial SCR Catalysts

Method and apparatus for microwave-assisted regeneration of SCR denitration catalyst

Study on impregnation process optimization for regenerating the spent V2O5-WO3/TiO2 catalysts

A novel regeneration method for deactivated commercial NH3-SCR catalysts with promoted low-temperature activities

Effect comparison of microwave heating and muffle heating on treatment of spent SCR catalyst

In Situ Treatment by High-Temperature Water Vapor As a Novel Health-Care Approach for Commercial SCR Catalyst

A Research on the Regeneration of Deactivated SCR Catalyst Used in Coal-Fired Plant

Potassium Deactivation and Regeneration Method of V_2O_5-WO_3/TiO_2 SCR Catalyst

New Approach to the Utilization of Microwave Thermal Energy: Desulfurization and Decarburization of Spent Catalyst Via Microwave Treatment

Microwave-assisted Catalytic Dehydration of Glycerol for Sustainable Production of Acrolein over a Microwave Absorbing Catalyst

A promising method to recover spent V2O5–WO3/TiO2 catalyst: treatment by vanadium–titanium magnetite sintering process

Regeneration of Ozone Decomposition Catalysts by Elimination of O22- from Oxygen Vacancies

Regeneration of Ozone Decomposition Catalysts by Elimination of O2 2 2- from Oxygen Vacancies

A clean and efficient approach for recovery of vanadium and tungsten from spent SCR catalyst

In Situ Regeneration of Commercial NH3-SCR Catalysts with High-Temperature Water Vapor

Hydrothermal Aging Treatment Activates V2O5/TiO2 Catalysts for NOx Abatement

Novel Methods for Assessing the SO2 Poisoning Effect and Thermal Regeneration Possibility of MOx-WO3/TiO2 (M = Fe, Mn, Cu, and V) Catalysts for NH3-SCR

Regeneration Of Commercial Scr Catalysts: Probing The Existing Forms Of Arsenic Oxide

NOxRemoval over V2O5/WO3–TiO2Prepared by a Grinding Method: Influence of the Precursor on Vanadium Dispersion

Effect of Dimethyl Formamide (DMF) on Vanadium Reloading over V-Ti SCR Catalyst

Regeneration of the Waste Selective Catalytic Reduction Denitrification Catalyst by Nitric Acid Washing