Numerical simulation of pulse-jet cleaning of bag house transformed from ESP in sintering machine tail

Xiaohong SONG,Wangsheng CHEN,Qianwei LI,Dantian LI,Ze LI
DOI: https://doi.org/10.12030/j.cjee.201606012
2017-01-01
Abstract:This paper presents the results of a study on the pulse jet cleaning of a baghouse transformed from an electrostatic precipitator (ESP) in a sintering machine tail.In order to make better use of the inner space of the ESP in the baghouse,a long filter bag and pulse-jet cleaning system was adopted.A numerical simulation of the time-average pressure in the injection pipe was performed using CFX software.The simulation result shows that there is negative pressure in the nozzle.Measures were taken to optimize the diameter of the holes set on the nozzle (now 20 mm),which resulted in effective increase in the gas flow of the pulse-jet.The best effect was observed when the number of holes was ‘ 2’ or ‘ 3 ’ Also studied were the effects of difference in the number of holes in the nozzle,pulse-jet pressures,pulse-jet distances,the spray aperture diameter,and filter bag lengths;on the peak pressure of the bag filter.The results indicate that the pulse-jet pressure and the spray aperture diameter have significant effects,and that increasing the pulse-jet pressure and spray aperture diameter help to improve the cleaning efficiency.The number of nozzle holes has less effect than the pulse-jet pressure and diameter of the spray aperture.The pulse-jet-distance affects only the cleaning efficiency of the bag-filter top.The filterbag length has the most effect on the cleaning efficiency of the bag-filter bottom,but this effect is small.Therefore,the use of long filter bags is feasible for use in baghouses transformed from ESPs.
What problem does this paper attempt to address?