Abstract:Selective catalytic reduction technology is the most commonly used method for NOx control, but the preparation process of the catalysts is complicated and the preparation cost is high. In this study, a novel low-cost catalyst for selective catalytic reduction of nitrogen oxides was prepared by treating vanadium-bearing steel slag with calcination modification and sulfuric acid modification. The activity test results show that the calcination modification can slightly improve the high-temperature activity of the catalysts. Among acid-modified catalysts, sulfuric acid modification can greatly improve the denitration activity of the catalyst, and calcination of the catalyst before sulfuric acid modification can obtain a higher activity denitration catalyst. The NOx removal efficiency of VSS-C-S catalyst reached 82.4% at 250°C. In addition, the catalyst modified with sulfuric acid after calcination has better water and sulfur resistance and regeneration performance. In the case of high water vapor and sulfur dioxide concentration, its denitration efficiency is 62.5%. The characterization results show that both calcination modification and sulfuric acid modification can promote the formation of α-Fe2O3, but calcination modification reduces the specific surface area and redox capacity of the catalysts. The sulfuric acid modification can form a new pore structure and a large number of sulfate species on the catalyst surface, and improve the existing state of vanadium species in the catalysts. The specific surface area of VSS-C-S catalyst is 43.90m2·g-1. Meanwhile, the adsorbed oxygen content of VSS-C-S catalyst is 24% higher than that of VSS-S-5 catalyst. It shows that the modification effect of sulfuric acid can be better exerted by calcination first and then modification with sulfuric acid. The results of in-situ DRIFTS experiments show that the NH3-SCR reaction of the calcined modified catalyst mainly follows the L-H mechanism. The NH3-SCR reaction of sulfuric acid-modified catalysts mainly follows the E-R mechanism. The active sites on the VSS-C-S catalyst surface adsorb a large amount of NH3 species and activate them as NH2 active intermediates, which directly react with gaseous NO. Therefore, the catalyst modified with sulfuric acid after calcination has higher activity. The work provides a novel idea for reducing catalysts cost and promoting cleaner production.

Study on the Removal of NOX from Sintered Flue Gas by Vanadium Sintered Ore

Selective Autocatalytic Reduction of NO from Sintering Flue Gas by the Hot Sintered Ore in the Presence of NH3

NOxremoval Coupled with Energy Recovery in Sintering Plant

In-situ DRIFTS Investigation on the Selective Catalytic Reduction of NO with NH3 over the Sintered Ore Catalyst

Intensification of NO x Conversion over Activated Coke by Ozone Oxidation for Sintering Flue Gas at Low Temperatures

Selective Catalytic Removal of High Concentrations of NOx at Low Temperature

Study on the SCR Properties of Vanadium-based De-NOx Catalyst at Mid-low Temperature

A Novel Activated Vanadium Extraction Tailing Catalyst for NOX Removal in NH3-SCR

Influence of Calcination Temperature over Vanadium–Molybdenum Catalysts for the Selective Catalytic Reduction of NOx with NH3

Improvement of the Activity of Γ-Fe2o3 for the Selective Catalytic Reduction of NO with NH3 at High Temperatures: NO Reduction Versus NH3 Oxidization

Vanadium-bearing steel slag catalysts for selective catalytic reduction of NOx by NH3

Studies on Simultaneous Catalytic Removal of NOX and SO2

SiO_2-supported vanadium oxide catalyst for SO_2 and NO removal

Influence of Calcination Temperature over Vanadium–Molybdenum Catalysts for the Selective Catalytic Reduction of NO x with NH 3

Mechanism and Performance of the SCR of NO with NH3 over Sulfated Sintered Ore Catalyst

Low Temperature Selective Catalytic Reduction of NO and NO2 with NH3 over Activated Carbon-Supported Vanadium Oxide Catalyst

NOxRemoval over V2O5/WO3–TiO2Prepared by a Grinding Method: Influence of the Precursor on Vanadium Dispersion

Heteroatoms doped iron oxide-based catalyst prepared from zinc slag for efficient selective catalytic reduction of NOx with NH3

Active Vanadium(IV) Species Synthesized at Low-Temperature Facilitate Excellent Performance in Low-Temperature NOx-Catalytic Removal

Highly Efficient Mesoporous V2O5/WO3–TiO2 Catalyst for Selective Catalytic Reduction of NOx: Effect of the Valence of V on the Catalytic Performance

Characteristics of Vanadium-Based Coal Gasification Slag and the NH3-Selective Catalytic Reduction of NO