Abstract:The chemical and geotechnical properties of solidified/stabilized (s/s) municipal solid waste incineration (MSWI) fly ash are of prime importance for the design and operation of landfill sites. This study conducted field and laboratory tests to investigate aging effects on the chemical and geotechnical properties of s/s MSWI fly ash. Field investigations included borehole sampling and cone penetration tests (CPTs), and laboratory analyses included the measurement of the chemical, physical, hydrological, and mechanical properties of s/s fly ash with different fill ages. The results showed that: 1) Cl concentrations in landfill leachate were as high as 52,700 mg.L-1, which may present a technical challenge for leachate treatment; 2) specific gravity decreased with fill age, which was attributed to the leaching of metal elements from the s/s fly ash; 3) mean particle size decreased with fill age, resulting in an increase in the gravimetric moisture retention capacity (MRC) and a decrease in the saturated hydraulic conductivity; 4) gravimetric MRC was much higher than the initial moisture content, suggesting water absorption by s/s fly ash after landfilling; and 5) shear strength decreased with fill age, which was consistent with the CPTs results. To improve the design and operation of s/s MSWI fly ash landfill sites, the following suggestions are made: 1) the use of concentrated MSW landfill leachate in the s/s fly ash process should be avoided to reduce the concentrations of subsequent landfill leachate; 2) leachate generation could be further reduced by improving landfill operation practices and by taking advantage of the absorption capacity of s/s fly ash; and 3) the specific geotechnical parameters of s/s fly ash should be obtained prior to the design of landfill sites, and their aging effects should also be taken into consideration.

Characteristics of Bottom Ash from Municipal Solid Waste Incineration for Resource Utilization

Content, Mobility and Transfer Behavior of Heavy Metals in Mswi Bottom Ash in Zhejiang Province, China

PHYSICAL AND CHEMICAL CHARACTERIZATIONS OF MSWI BOTTOMASH

Measurements of geotechnical properties of municipal solid waste incineration fly ash stabilized by chemical reagents

Solidification of dewatered sewage sludge using bottom ash of MSWI as skeleton material

Chemical and Geotechnical Properties of Solidified/stabilized MSWI Fly Ash Disposed at a Landfill in China

Characteristics Investigation of the Solid Residues from CFB Municipal Solid Waste Incinerator

Study of Ashes from a Medical Waste Incinerator in China: Physical and Chemical Characteristics on Fly Ash, Ash Deposits and Bottom Ash

A review on the utilization of municipal solid waste incineration (MSWI) bottom ash as a mineral resource for construction materials

Typical Pollutants in Bottom Ashes from a Typical Medical Waste Incinerator

Analysis of composition characteristics and treatment techniques of municipal solid waste incineration fly ash in China

Stabilization of the misfit layer compound (PbS)1.13TaS2 by metal cross substitution.

Beneficial Reuse of Municipal Solid Waste Incineration Bottom Slag in Civil Engineering

Characteristics and release potential of microplastics in municipal solid waste incineration bottom ash

Study on the Leachability of Heavy Metals and Polycyclic Aromatic Hydrocarbons from MSW Incineration Bottom ash

Content and fractionation of Cu, Zn and Cd in size fractionated municipal solid waste incineration bottom ash.

Impacts of wet treatment on leaching toxicity of municipal solid waste incineration bottom ash

Effect of Source-Classified Collection of Municipal Solid Waste on Heavy Metals and Pozzolanic Properties of Incineration Residues

Analysis of the Reuse of Municipal Solid Waste Fly Ash

Characteristics of incineration ash for sustainable treatment and reutilization

[Analysis of Pollution Characteristics of Solid Waste Incinerator Fly Ash in Zhejiang Province].