Abstract:As turbine inlet temperature gets higher and higher, thermal barrier coating (TBC) is more and more widely used in turbine blades. For turbine blades with TBC, it is of great significance to evaluate the temperature distribution of its substrate metal quickly and accurately, especially during the design stage. With different degrees of simplification such as whether to consider the change of the geometric size of the fluid domain by TBC and whether to consider the planar heat conduction in TBC, three different methods used in conjugate heat transfer (CHT) simulation to model the TBC of the turbine blades have been developed and widely used by researchers. However, little research has been conducted to investigate the influence of the three methods on the temperature distribution of turbine blade. To fill this gap, three geometric models were designed. They are a solid conduction model with a substrate metal layer and a TBC layer, a transonic turbine vane with internal cooling and TBC, and a plate cylindrical film hole cooling model with TBC. Different methods were used in these geometric models and their differences were carefully analyzed and discussed. The result shows that for the conduction model used in this paper, with the same TBC surface temperature distribution, the difference between the three methods is very small and can be ignored. For a transonic turbine vane with internal cooling, regarding the local maximum temperature of the substrate-TBC interface, the largest difference between the method in which TBC is considered as a thermal resistance or a virtual layer of cells and the method in which three-dimensional heat conduction equation of TBC is solved occurs at the trailing edge. The difference near the leading edge is below 2 K. When employed to the film cooling model, the difference of the laterally averaged temperature of the substrate-TBC interface can be 8 K which is mainly due to the change of the length to diameter ratio of the film cooling hole by TBC. If the substrate thickness is reduced by the thickness of TBC when three-dimensional heat conduction equation of TBC is solved, the temperature difference between the three methods will be quite limited.

Study on thermometry of leading edge of rotating turbine blade by thermochromic liquid crystal

Study on Effects of Modern Turbine Blade Coolant Injecting Nozzle Position on Film Cooling and Vortex Composite Performance under Rotating Conditions

Dynamical Temperature Monitoring System Design for High-speed Cutting Based on Thin-film Thermocouples

A TEMPERATURE-GRADIENT CORRECTION METHOD FOR FILM COOLING EFFECTIVENESS MEASUREMENT USING ENDOSCOPE-BASED PSP TECHNIQUE

An Experimental Study of Turbine Vane Film Cooling Using Endoscope-Based PSP Technique in a Single-Passage Wind Tunnel

A Study on Thermo-Camera Using Liquid Crystal. Method of Multiple Regression Between Color and Temperature.

Application of transient liquid crystal on internal cooling research of gas turbine airfoil

Improved Liquid-Crystal Thermometry Excluding Human Color Sensation

Temperature field measurement of turbine rotor blade leading edge based on infrared radiation pyrometer

An Experimental and Numerical Study on the Liquid Cooling of a Gas Turbine Blade

Uncertainties of the Transient Thermochromic Liquid Crystal Method in Gas Turbine Internal Cooling Measurements

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

Numerical Investigation of Film Cooling Effectiveness on a Rotating Turbine Blade Model

Comparative Study on Different Methods for Prediction of Thermal Insulation Performance of Thermal Barrier Coating Used on Turbine Blades

Film cooling effectiveness of a leading-edge cooling array of a rotating turbine blade with twist

Experimental study on cooling performance of a steam-cooled turbine blade with five internal cooling smooth channels

Dynamic Measurement of Temperature Field and Deformation in Hydraulic Turbine Blade at Cooling Stage of Heat Treatment

A Novel Indirect Visualization Method for Studying the Melting Heat Transfer of Nano-Enhanced Phase Change Materials Using Thermochromic Liquid Crystal Thermography

Preparation and characterization of phase change material emulsions and their applications in liquid cooling systems for wind turbines

Fiber Optic Array Temperature Field Measurement System for High-Temperature Turbine Blades

Measurements of Heat Transfer and Pressure in a Trailing Edge Cavity of a Turbine Blade