Abstract:As turbine inlet temperature gets higher and higher, thermal barrier coating (TBC) is more and more widely used in turbine blades. For turbine blades with TBC, it is of great significance to evaluate the temperature distribution of its substrate metal quickly and accurately, especially during the design stage. With different degrees of simplification such as whether to consider the change of the geometric size of the fluid domain by TBC and whether to consider the planar heat conduction in TBC, three different methods used in conjugate heat transfer (CHT) simulation to model the TBC of the turbine blades have been developed and widely used by researchers. However, little research has been conducted to investigate the influence of the three methods on the temperature distribution of turbine blade. To fill this gap, three geometric models were designed. They are a solid conduction model with a substrate metal layer and a TBC layer, a transonic turbine vane with internal cooling and TBC, and a plate cylindrical film hole cooling model with TBC. Different methods were used in these geometric models and their differences were carefully analyzed and discussed. The result shows that for the conduction model used in this paper, with the same TBC surface temperature distribution, the difference between the three methods is very small and can be ignored. For a transonic turbine vane with internal cooling, regarding the local maximum temperature of the substrate-TBC interface, the largest difference between the method in which TBC is considered as a thermal resistance or a virtual layer of cells and the method in which three-dimensional heat conduction equation of TBC is solved occurs at the trailing edge. The difference near the leading edge is below 2 K. When employed to the film cooling model, the difference of the laterally averaged temperature of the substrate-TBC interface can be 8 K which is mainly due to the change of the length to diameter ratio of the film cooling hole by TBC. If the substrate thickness is reduced by the thickness of TBC when three-dimensional heat conduction equation of TBC is solved, the temperature difference between the three methods will be quite limited.

Uncertainties of the Transient Thermochromic Liquid Crystal Method in Gas Turbine Internal Cooling Measurements

Temperature Stability of a Joule–Thomson Microcooler Operating with Pure and Mixed Gases

Determining mainstream reference temperature using the non-dimensional temperature analysis in the transient liquid crystal technique

Application of transient liquid crystal on internal cooling research of gas turbine airfoil

A TEMPERATURE-GRADIENT CORRECTION METHOD FOR FILM COOLING EFFECTIVENESS MEASUREMENT USING ENDOSCOPE-BASED PSP TECHNIQUE

A Novel Indirect Visualization Method for Studying the Melting Heat Transfer of Nano-Enhanced Phase Change Materials Using Thermochromic Liquid Crystal Thermography

Comparison of Temperature Difference Measurement Technologies Used in Vehicular Heat Exchangers

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

Simultaneous Determination of Reference Free-Stream Temperature and Convective Heat Transfer Coefficient

Improved Liquid-Crystal Thermometry Excluding Human Color Sensation

Numerical and Experimental Study on a Tube-in-tube Heat Exchanger Working at Liquid-Hydrogen Temperature with a Large Temperature Span

Measurement of Boiling Heat Transfer Coefficient in Liquid Nitrogen Bath by Inverse Heat Conduction Method

Numerical Simulation and Experimental Verification of Dynamic Cooling and Temperature Control of the Optical Cavity in a Co2 Isotope Analyzer

Dynamic compensation by coupled triple-thermocouples for temperature measurement error of high-temperature gas flow

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Quantification of Heat Transfer Coefficient in Transient Liquid Crystal Experiments

Relationship between Color and Temperature in Liquid Crystal. Effects of Temperature Gradient and Measuring Angle.

An Experimental and Numerical Study on the Liquid Cooling of a Gas Turbine Blade

Heat transfer error analysis of high-temperature wall temperature measurement using thermocouple

Aero-thermo dynamical characteristics in a ribbed trapezoidal internal cooling system

Comparative Study on Different Methods for Prediction of Thermal Insulation Performance of Thermal Barrier Coating Used on Turbine Blades