Abstract:Atomic layer deposition (ALD) is an emerging coating deposition technique filled with potential that is expected to deposit coatings with high laser-induced damage threshold (LIDT). As lasers play an important role in space exploration which are gradually moving to higher orbits and longer lifetimes, a higher demand for space laser coatings has been raising. At the current state of the art, the reliability of ALD-deposited laser coatings for space applications is unclear. This work presents investigations on the stability of three ALD-deposited oxide coatings under space proton and UV radiation at values typical for space environment. Changes in the coatings containing low and high amounts of impurities under space radiation were analyzed through optical parse and composition analysis respectively. Both SiO 2 and Al 2 O 3 coatings with few impurities generated color centers after irradiation, which resulted in increased absorption loss and reduced transmittance and optical band gap, and increased probability of damage under laser irradiation. However, the changes in the ZrO 2 coating were surprising, when the ZrO 2 coating with a large amount of impurities was exposed to radiation, the impurity atoms bound to Zr were displaced first, and the released Zr combined with the oxygen vacancies in the coating, which reduced the number of defects, reduced the absorption loss of the coating, and led to a higher transmittance and an increased optical band-gap. This work provided a novel insight on the impact of the impurities on the stability of the ALD-manufactured oxide coatings against laser-induced damage in effect with space proton and UV radiation. Additionally, we show that high initial LIDT in ALD-prepared oxides may be compromised by the space radiation, while fine tuning of the impurities may result a mitigation approach leading to enhanced laser coatings for space applications.

Tests for contamination enhanced and laser-induced damage in spaceborne lidar system and its prevention

Researches on Laser Damage Resistance of Optical Films

Laser-induced damage and contamination testing for the next generation of LIDAR space optics

Design of detection optical system with large relative aperture

Spaceborne Environmental Detection Lidar and Its Key Techniques

Laser-induced molecular contamination de-risking activity for the Laser Interferometer Space Antenna

Effect of residual impurities on the behavior and laser-induced damage of oxide coatings exposed to deep space radiation

Design of Lidar Data Acquisition and Control System in High Repetition Rate and Photon-Counting Mode: Providing Testing for Space-Borne Lidar

Verification and analysis of stray light in high-power laser system

Analysis of the Effects on Ultra-Short Laser Pulse Beam Quality Caused by Errors in Optical Systems

A review of thermal effects and substrate damage control in laser cleaning

Thermal Isolation and Thermal Sensing Technologies of Spacecraft under Laser Irradiation

Study on the Control of Micro-Environmental Parameters in Long Distance Laser Interferometry

Research on LDV stray light suppression technology based on four-wave hybrid interference

Simulation of Contamination Prevention for Optical Window in Laser Ignition Systems of Large-Caliber Guns

Modeling and Simulation on Ground-based Lasers Cleaning Space Debris

Experimental study about laser induced damage to photovoltaic detectors in vacuum

Design of Data Communication and Management System for Ground Test and Verification Devices of Space Laser Communication

Development of space-based laser weapon systems

Parameter Optimization and Development of Mini Infrared Lidar for Atmospheric Three-Dimensional Detection

Review of Photodetectors for Space Lidars