Abstract:Due to the simple design and convenient construction of prestressed concrete box girder bridges, it is widely used in bridge construction in China. At present, the load test of bridge is the most direct and effective method to evaluate the actual bearing capacity of the structure. However, this method has barriers including high cost, long time, and unfriendly to the damaged structure. Besides, the calculation method of the ultimate bearing capacity of damaged structures is relatively subjective and uncertain. Therefore, this study combines the full-size model test results of a newly built 30 m prestressed concrete box girder, and the mechanical properties of the test beam under three different working states (elastic, elastic-plastic, and plastic stage) are obtained. The stiffness degradation and bearing capacity change law of precast prestressed concrete box girder during failure are investigated. Two different stiffness damage reduction coefficients are defined. Combined with the structural characteristics of this kind of precast prestressed concrete box girder and the calculation formula of flexural rigidity of cracked members given by the code, the calculation formula of the actual residual bearing capacity of members is proposed based on the stiffness damage reduction coefficient. The results show that the reduction coefficients of flexural stiffness defined by the two methods have the same variation trend. The stiffness reduction effect of the box girder after damage is evident. The stiffness reduction of the box girder from the cracking damage to the ultimate bearing capacity state is about 40%, and the stiffness reduction of the two adjacent sections can be approximately linear distribution. The deviation between the residual bearing capacity calculated based on the stiffness damage reduction coefficient and the test value is less than 5%. Combined with the distribution law of the stiffness reduction coefficient along the longitudinal section of the box girder, the distribution law of the actual residual bearing capacity along the longitudinal section of the box girder after the damage occurred in the midspan section can be calculated. This calculation method changes the previous assessment method of structural technical condition from qualitative assessment to quantitative assessment, which can be the reference for evaluating the technical condition of damaged bridges and the calculation of residual bearing capacity in engineering.

Design of Transverse Concrete Block of Continuous Girder Bridge Considering Collision Effects

Static Shear Performance and Residual Axial Capacity of Rectangular RC Bridge Piers under Near-Ground Lateral Loads

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

Impact Analysis and Absorber Design for Collision Protection of Part-Buried Structures

Experimental and Numerical Study on the Behavior of Circular RC Columns under Impact Loading

Field Test and Analysis for the Static and Dynamic Behaviour of Multi-Box Steel Concrete Composite Girder Bridge

Study on Inhomogeneous Collision Effect of Curved Girder Bridge under Seismic Action

Influence analysis of group studs stiffness in accelerated construction steel-concrete composite small box girder bridges

Accurate FEM of Steel-Concrete Composite Box Girder Bridge for Damage Identification Based on Dynamical Experimental Study

Experimental Investigation of a Slip in High-Performance Steel-Concrete Small Box Girder with Different Combinations of Group Studs

Structural Performance and Strength Prediction of Steel-To-Concrete Box Girder Deck Transition Zone of Hybrid Steel-Concrete Cable-Stayed Bridges

Damage Analysis of Box Girder Based on a Vehicle–Bridge Interaction System

Research on Residual Bearing Capacity Calculation Method and Changing Law of Prestressed Concrete Box Girder with Damage

Dynamic response performance of bridge piers under non-bottom vehicle collision

Scaled Model Test for Collision Between Over-Height Truck and Bridge Superstructure

Nonlinear seismic response and damage analysis for continuous prestressed concrete rigid-frame bridge considering internal force state under near-fault ground motions

Experimental and Numerical Analysis of Reinforced Concrete Columns under Lateral Impact Loading

Experiment on Dynamic Response of Piers Subjected to Rolling Stone Impacting

Analysis of Mechanical Characteristics of Steel-Concrete Composite Flat Link Slab on Simply-Supported Beam Bridge

Experiment of Bearing Performance of Main Pier of Shijiu Lake Bridge Subjected to Ship Collision Load

Damage evaluation and performance-based design of double-pier RC bridge subjected to vehicle collision