Abstract:To analyze the dynamic load of heavy vehicle at the bridge expansion joint, a computational method based on spring-damping element is presented with the contact length between the tire and the road as well as the dynamic characteristics of the wheel considered. The process of the tire passing through the expansion joint is divided into three stages: going down, spanning and going up the expansion joint. Combined with the dynamic finite element analysis of the vehicle, the vertical dynamic load of the tire passing through the expansion joint could be calculated. As an example, the dynamic load of the heavy vehicle passing through the single-gap expansion joint is analyzed, the results indicate that: (1) The calculated displacement at the bottom of the tire is much smaller than the values available in the literature, leading to a smaller tire load; (2) The impact factor of the tire load in heavy-vehicle bumping at expansion joint may be higher than the value provided by the Chinese or European design codes of bridge, and hence more attentions should be paid; (3) The maximum dynamic load is proportional to the width of the expansion joint, and hence the impact factor could be reduced by decreasing the gap width; (4) Lower the vehicle speed may not lead to smaller impact factor at the bridge expansion joint, because the maximum impact factor usually occurs at a medium speed; (5) The maximum dynamic load mainly occurs near the expansion joint, and hence it is only necessary to strengthen the local structure near the expansion joint.

Analysis of EPS Cushion on Bridge Head Embankment of Highway

Analysis of dynamic load of vehicle bumping at bridge-head using distributed spring-damper element

A computational method for the dynamic load in heavy-vehicle bumping at the bridge expansion joint and analysis of the influencing factors

Analysis of cast-in-situ tubular piles in soft foundation improvement at bridge approaches

Characteristic study on composite foundation with rigid-flexible piles under the load from embankment

Study on causes of post-construction settlement of DJM pile composite foundation at bridge approaches

BACK-ANALYSIS OF VISCO-ELASTIC PARAMETERS OF FILLING MATERIALS AND SETTLEMENT PREDICTION FOR HIGH-FILLED EMBANKMENT

STUDY ON THE SETTLEMENT LAW OF THE COMPOSITE GROUND UNDER A FLEXIBLE FOUNDATION

Finite Element Analysis of Deformation Characteristics of Composite Foundation with Rigid-Flexible Piles

Field Experimental Study on Compound Foundation of Dry Jet Mixing Pile in Highway

Two-dimensional Back-analysis and Prediction of Settlement of Soft Clay Ground of Highway's Embankment

Performance analysis of cast-in-place tubular pile composite ground under embankment load

Preliminary Study on Floating Piles and Sandwiched Hard Layers in Strengthening Weak Foundation of Highway

Analysis of the Deep-Seated Concrete Slab for Settlement Control at Bridge Approach Embankment

FIELD SURVEY OF COMPOSITE FOUNDATION WITH RIGID PILES UNDER EMBANKMENT

Numerical analysis on the performance of a cushioned foundation with a mixture of both rigid and flexible piles

Case Study of the Deep-Seated Concrete Slab for Settlement Control at Bridge Approach Embankment

Field Test of Two Methods for Alleviating Bridge-Head Jumping at Deep Soft Foundation

Analysis of Behavior of Rigid Pile-Supported Embankment in Soft Ground

Construction Technology for Roadbed and Pavement of Highway Bridge Settlement Section

Performance of Deep Braced Excavation under Embankment Surcharge Load