Abstract:The spherical pressure hull used in the manned cabin of deep-sea submersibles endures low-cycle fatigue problems during the process of cyclic submergence and recovery, but fatigue testing on its full-scale model is difficult to conduct. To approximate the problem, the paper proposed the design of an L-type equivalent welding joint to simulate the status of the strengthened part of the spherical pressure hull under a certain cyclic axial pressure history. The design principle of the equivalent welding joint is to ensure that the stress ratio between inner and outer surface and the distribution of the simulated test piece should be similar to or smaller than the actual stress distribution characteristics in the critical zone of the spherical hull for conservative consideration. The angle of the L-type joint is 175° in the present study, at which the stress on the outside is at the turning point from compressive stress to tensile stress. The fatigue experiment of the equivalent welding joint is conducted with measurements of crack growth and residual stresses. Multiple cracks are observed in the vicinity of the weld, which grows showing a typical low-cycle fracture morphology. The three-dimensional finite element modelling for the equivalent welding joint with prefabricated notch and the same weld zone shape with its tested piece is carried out. An improved crack growth model proposed by the author's group, considering multiple factors, is adopted for crack growth calculation and compared with experimental results, which shows satisfactory agreement. The finite element modelling based on the pre-designed L-type joint combined with the improved crack growth rate model can be applied as a simplified method to simulate the fatigue life of the spherical pressure hull.

Effect of welding residual stress on the ultimate strength of spherical pressure hull

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Experimental and numerical study on compressive behavior of welded hollow spherical joints with external stiffeners

Buckling Strength of Tapered Cylindrical Shells under Partial Axial Compression: Effect of Circumferential Weld-Induced Imperfections

Effect of Welding Residual Stress on Plastic Buckling of Axially Compressed Cylindrical Shells with Patterned Welds

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Influence of Initial Imperfections on Ultimate Strength of Spherical Shells

Effect of Residual Stress on the Ultimate Bearing Capacity of Titanium Alloy Pressure Spherical–Cylindrical-Combined Shells

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Influences of Initial Imperfection Due to Welding on the Ultimate Bending Moment of Ship Hull Girder

The Effect of Welding Residual Stress on the Free Vibration of Underwater Cylindrical Shell

Effect of Weld Reinforcement on Axial Plastic Buckling of Welded Steel Cylindrical Shells

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Fatigue analysis of spherical shell considering residual stress

EXPERIMENTAL STUDY OF WELDING RESIDUAL STRESS OF HIGH-STRENGTH SHIPBUILDING STEEL

Influence of welding residual stress on bending resistance of hollow spherical joints

Effect of welding residual stress on the performance of CFST tubular joints

Research of Directional Stress Distribution on the Fully Plastic Bulged Pressure Hull

A physically consistent 2D residual stress model for approximating 3D effects in welding

The Influence of Welding-Induced 3D Residual Stress and Distortion on the Ultimate Strength of Multi-Stiffened Thin Plate Structures under Cyclic Load

Experimental Observation and Simulation on Crack Growth Behavior of An Equivalent Welding Joint for A Deep-Sea Spherical Hull