Abstract:This study aims to investigate the magnitude and distribution of welding residual stresses in orthotropic steel decks stiffened with U-shaped ribs. Numerical simulation of the welding residual stresses is performed using the thermal elastic–plastic finite element method. The residual stresses are subsequently measured using the hole-drilling strain-gage method. Based on the results of this study, it can be determined that: (1) The longitudinal welding residual stresses (σz) in the weld zones are tensile stresses, where the peak value exceeds the minimum yield strength (fyl); however, relatively low compressive stresses exist in the areas located far away from the welds; (2) The stress gradient in the weld zone is steep, and the widths of the areas experiencing tensile stress are narrow; (3) In the case of the upper surface of the deck, the weld that is first deposited has the highest peak stress, while similar stresses are determined for the remaining welds. In the case of the lower surface of the deck, the peak stress in the weld zones is greater than that on the upper surface; (4) In the case of the weld zone of the U-shaped ribs, the tensile stresses reach up to 1.15fyl; however, at locations a short distance away from the welds, the σz varies from tensile to compressive, and finally transforms into a small tensile stress at the base of the U-shaped ribs. In addition, the simulated and measured σz are compared, and the deviation between them is analyzed.

EXPERIMENTAL STUDY OF WELDING RESIDUAL STRESS OF HIGH-STRENGTH SHIPBUILDING STEEL

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Design and Analysis of a Novel Ship Pipeline Welding Auxiliary Device

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Research on Welding Residual Stress Measurement Using Electromagnetic Acoustic Transducer

Experimental investigation and numerical simulation on welding residual stress of innovative double-side welded rib-to-deck joints of orthotropic steel decks

Numerical Simulation and Measurement of Welding Residual Stresses in Orthotropic Steel Decks Stiffened with U-Shaped Ribs

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Effect of Welding Residual Stress on Plastic Buckling of Axially Compressed Cylindrical Shells with Patterned Welds

Investigation on residual stress of EQ56 high strength steel butt weld

RESIDUAL STRESS OF WELDED I SECTIONS FABRICATED FROM HIGH PERFORMANCE STEEL: EXPERIMENTAL INVESTIGATION AND MODELLING

Numerical and experimental study on thermal-metallurgical-mechanical behavior of high-strength steel welded joint

EXPERIMENTAL AND UNIFIED MODEL INVESTIGATIONS ON RESIDUAL STRESS WITHIN HIGH STRENGTH STEEL WELDED I-SECTIONS

Nondestructive Measurement System for Welding Residual Stress by Ultrasonic Method

Effect of welding residual stress on the ultimate strength of spherical pressure hull

The Influence of Welding-Induced 3D Residual Stress and Distortion on the Ultimate Strength of Multi-Stiffened Thin Plate Structures under Cyclic Load

Numerical Study on Welding Residual Stress Distribution of Corrugated Steel Webs

Experimental Research of Welding Residual Stress of Butt Welded Joint of Thick Steel Plate

Effect of Strain Hardening Constitutive Relations on Weld Residual Stress Simulation of Dissimilar Metal Weld

Experimental and numerical study on welding residual stress of U-rib stiffened plates

Study on Joint Residual Stress Induced by Laser Beam Welding of High Strength Automobile Thin Sheet