Abstract:Prediction of two-phase boiling flows using the computational fluid dynamics (CFD) approach is very challenging since several sub-models for interfacial mass, momentum and energy transfer in such flows are still not well established and require further development and validation. Once validating a particular model, it is important that all key parameter involved in the model are carefully verified. Such verification is typically performed by separate effect tests, where one parameter at a time is compared to a measured or otherwise known value. Needless to say that for complex models, which are typical for CFD applications to two-phase flow, the number of independent parameters that need to be verified can be quite high. This particular feature makes the validation process of complex CFD models in open source codes very attractive, since full access to the implementation details is possible. This paper is concerned with implementation and validation of two-phase boiling bubbly flow models using the OpenFOAM, open source environment. The model employs the two-fluid formulation of the conservation equations with the Reynolds-averaged treatment of the turbulent terms. The model consists of six conservation equations for the liquid and the vapor phase, allowing for the thermodynamic non-equilibrium and compressibility of both phases. In addition, the model includes two transport equations for the turbulence kinetic energy and energy dissipation and one transport equation for the interfacial area concentration. New models for wall heat partitioning as well as for the phase change terms in nucleate boiling have been implemented. Sensitivity studies as well as validation of the model against measured data available in the open literature have been performed and it has been shown that a reasonable agreement between predictions and experiments has been achieved.

Evaluation and Correction of Low-Pressure Subcooled Flow Boiling Model for Athlet Code

ICONE23-1046 MODELLING OF LOW-PRESSURE SUBCOOLED FLOW BOILING USING ATHLET CODE

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

CFD Investigation of Subcooled Flow Boiling Model under Low Pressure

Critical Heat Flux Prediction Model for Low Quality Flow Boiling

ICONE19-43858 an Improved Critical Heat Flux Prediction Model for Subcooled and Low Quality Flow Boiling under Motion Condition Based on Microscopic Mechanism

Evaluation of several liquid–vapor phase change models for numerical simulation of subcooled flow boiling

Modeling of Low-Pressure Subcooled Boiling Flow of Water Via the Homogeneous MUSIG Approach

A BUBBLE-LAYER-BASED MECHANISTIC MODEL FOR THE SLIGHTLY SUBCOOLED FLOW BOILING IN VERTICAL TUBES

Numerical Simulation of Subcooled Boiling Water in Vertical Concentric Annulus under Low Pressure

Investigation on the Effects of Model Uncertainties on Subcooled Boiling

Implementation and validation of two-phase boiling flow models in OpenFOAM

A Mechanistic Model for Slightly Subcooled Flow Boiling in Vertical Tubes

Development of a Sub-Channel Analysis Code Based on the Two-Fluid Model and Its Preliminary Assessment

Numerical Investigation of Flow Boiling Characteristics in Narrow Rectangular Channels Using Two-Fluid Eulerian Cfd Model Covering a Wide Range of Pressures

Feasibility Analysis of the Modified ATHLET Code for Supercritical Water Cooled Systems

A Unifying Bubble-Layer-Based Theoretical Model for Flow Boiling and Application to a Rod Bundle

Numerical investigation of static flow instability in a low-pressure subcooled boiling channel

Numerical Simulation of Subcooled Boiling Water at Low Pressure Incorporating Homogeneous MUSIG Model

Analysis of Spatial Nonuniform Behaviors of Subcooled Flow Boiling Employing Euler-Lagrange Approach

Theoretical model for subcooled upward flow boiling heat transfer and critical heat flux for an inclined downward heated surface