Steady Flow Torques in a Servo Motor Operated Rotary Directional Control Valve
He Wang,Guofang Gong,Hongbin Zhou,Wei Wang
DOI: https://doi.org/10.1016/j.enconman.2015.11.054
IF: 10.4
2016-01-01
Energy Conversion and Management
Abstract:In this paper, a servo motor operated rotary directional control valve is proposed, and a systematic analysis of steady flow torques in this valve is provided by theoretical calculation, CFD simulation and experimental test. In the analysis, spool rotation angle corresponding to the maximum orifice opening is tagged as 0 degrees. Over a complete change cycle of the orifice, the range of spool rotation angle is symmetric about 0 degrees. The results show that the direction of steady flow torques in this valve is always the direction of orifice closing. The steady flow torques serve as resistances to the spool rotation when the orifice opening increases, while impetuses to the spool rotation when the orifice opening decreases. At a certain pressure drop or flow rate, steady flow torques are approximately equal and opposite when at spool rotation angles which are symmetric about 0 degrees. When the spool rotates from 0 degrees, at a certain pressure drop, their values increase first then decrease with the spool rotation and reach their maximum values at an angle corresponding to about 1/2 of the maximum orifice opening, and at a certain flow rate, their values increase with the spool rotation. The steady flow torques in this valve are the sums of those in the meter-in and meter-out valve chambers. At a certain spool rotation angle, steady flow torques in the meter-in and meter-out valve chambers are approximately proportional to the pressure drop and the second power of the flow rate through the orifice. Theoretical calculation and CFD simulation can be validated by the experimental test. The proposed calculation formulas can predict the steady flow torques in the rotary directional control valve correctly. (C) 2015 Elsevier Ltd. All rights reserved.