A MEMS direct modulating wideband IR thermal source

Xinming Ji,Jing Peng,Xing Fang,Yiping Huang
DOI: https://doi.org/10.19335/j.cnki.2095-6649.2011.09.005
2011-01-01
Abstract:A micro thermal emitter based on electrically heated thin film has been studied for non-dispersive infrared gas sensor as a infrared source The IR source, with effectively emitting area of 2.0*2.0 mm2, is obtained from heated platinum thin film resistors that deposit on a Si3N4/SiO2 suspended membrane. IR radiation power of the emitter is up to 60mW and the energy efficiency ratio reaches 10.9%with the effective blackbody temperature ranged from 300 to 850K. Moreover, it shows very good dynamic parameters with a modulation frequency as high as 100Hz and response time 18.3ms, which make it suitable for fast NDIR measurements of concentration. It has been proven that the emitter can sever as a stable IR source in Non-dispersive infrared (NDIR) gas sensor. The NDIR used the microemitter has acceptable sensitivity and rapid response time with detection limits of 20ppm and 50ppm level for CO2 and SO2 respectively.
What problem does this paper attempt to address?