Abstract:After several years of development, 3D concrete printing (3DCP) technology has achieved considerable progress, with many research results in printing equipment, materials, mechanical properties of components, and simulation of printed concrete, which has also made 3DCP more controllable. The results showed that the mechanical properties of 3D printed concrete (3DPC) had obvious anisotropy according to the printing path. This article aims to provide a concise overview of the mechanical variations in 3DPC, specifically focusing on its anisotropic performance. It delves into the distinctions observed among various researchers who employ different printing materials, equipment, and associated printing parameters. We summarize the causes of anisotropy and introduce three present numerical simulation approaches for printed concrete. These methods involve utilizing anisotropic equivalent elements, employing defective layers with thickness, and integrating zero-thickness cohesive elements to mimic the behavior of 3DPC. In addition, this article will also compare above-mentioned three methods with the cube compression test of 3DPC. The findings show that the strength simulation values of the defect layer with thickness method in the X and Y directions are closest to the actual values, with deviations of only 3.7% and 0.7%, respectively, and the Z direction is slightly higher. The results of the zero-thickness cohesive element method are all higher than the experimental values. The results show that anisotropic equivalent elements method has the best computational efficiency, but cannot simulate the interlayer damage between concrete strips. Both defect layer with thickness method and zero-thickness cohesive element method could simulate interlayer damage; the former method has the best accuracy in strength and damage simulation, the latter one has a faster computing speed and easier modeling. This article can provide reference for future research on 3DPC simulation and select more suitable simulation methods based on different types of 3D printing structures and analysis focuses.

Fresh and Anisotropic-Mechanical Properties of 3D Printable Ultra-High Ductile Concrete with Crumb Rubber

Effect of polyethylene fiber content on workability and mechanical-anisotropic properties of 3D printed ultra-high ductile concrete

Development of 3D Printable Engineered Cementitious Composites with Ultra-High Tensile Ductility for Digital Construction

Rheological characterization of ultra-high performance concrete for 3D printing

Mechanical Properties and Failure Mechanism of 3D Printing Ultra-High Performance Concrete

Anisotropic mechanical properties of extrusion-based 3D printed layered concrete

Rheological and Harden Properties of the High-Thixotropy 3D Printing Concrete

3D-Printable Engineered Cementitious Composites (3DP-ECC): Fresh and Hardened Properties

Development of 3D-printable ultra-high performance fiber-reinforced concrete for digital construction

Eco-friendly 3D printed concrete with fine aggregate replacements: Fabrication, characterization and machine learning prediction

PVA Fibre Reinforced High-Strength Cementitious Composite for 3D Printing: Mechanical Properties and Durability

Mechanical Performance of Commercially Available Premix UHPC-Based 3D Printable Concrete

Mechanical performance and anisotropic analysis of rubberised 3D-printed concrete incorporating PP fibre

Mechanical behaviors of 3D printed lightweight concrete structure with hollow section

Mechanical anisotropy, rheology and carbon footprint of 3D printable concrete: A review

Anisotropic Behavior in 3D Printed Concrete: Finite Element Simulation Approach

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate

Three-Dimensional Printable Concrete by an Ultra-Thin Nozzle and Fully Sealed Extrusion

Extrusion-based 3D Printing Concrete with Coarse Aggregate: Printability and Direction-Dependent Mechanical Performance

Study on anisotropy of 3D printing PVA fiber reinforced concrete using destructive and non-destructive testing methods

Finite Element Analysis on the Anisotropic Behavior of 3D Printed Concrete under Compression and Flexure