Abstract:Fly ash (FA) contents and water-binder ratio ( w / b ) are the important factors influencing the mechanical characteristics of cement-based materials, meanwhile the porous structure of material plays a vital role. The compressive strength and water permeability of cement-based samples with high-volume FA contents (0%, 30%, 40%) and different w / b (0.3, 0.4, 0.5) were measured. The results demonstrated that higher FA contents or greater w / b led to lower compressive strength and higher water permeability at an early stage. The pore structure features of samples were obtained using mercury intrusion porosimetry and low-temperature nitrogen gas adsorption (LT-NGA). The pore size distributions (PSDs) and the matrix compressibility in cementitious materials were also analyzed, with the compression coefficient K C ranging from 11.919 to 1.249 × 10 −4 MPa −1 . Increasing the FA content and reducing the w / b resulted in an optimized pore structure of the samples, characterized by changing the main pore type from mesopores (10–50 nm) to micropores (< 10 nm). The pores and fractures in the samples also had distinct multifractal characteristics. The strongest negative correlation between the compressive strength and the width of the multifractal generalized spectrum was proved by Pearson correlation analysis, and the correlation coefficient ( ρ ) was − 0.93. Furthermore, the water permeability had the strongest positive correlation with porosity, with ρ of 0.91. The content of macropores (50–10 μm) had greater influence on its macroscopic properties. The dense structure accompanied by homogeneous PSDs is advantageous for enhancing the strength and anti-permeability properties of cement-based materials.

Quantitative Relationship Between Pore Size Distribution and Compressive Strength of Cementitious Materials

A new method for predicting compressive strength of cement-based materials

Statistical Modelling of Compressive Strength Controlled by Porosity and Pore Size Distribution for Cementitious Materials

Empirical Estimation of Pore Size Distribution in Cement, Mortar, and Concrete

A Novel Strength Model for Cement Marine Clay Based on the Mechanical-Chemical Coupling Behavior

Relationship Modeling of Pore Structure and Strength of Concrete

Relationship Between Microscopic Pore Structure and Strength of Cement-Based Materials with Low Water-Binder Ratio Under Sulfate Attack Environment

Study of the Relationship between the Strength of the hydrated Cement Paste with Flyash and its Pore structure

Segmented Fractal Pore Structure in Cement-Based Materials Blended with Dolomite Powder

Measurement of Permeability and the Correlation Between Permeability and Strength of Pervious Concrete

Effects of Water-to-Cement Ratio on Pore Structure Evolution and Strength Development of Cement Slurry Based on HYMOSTRUC3D and Micro-CT

Strength, Permeability and Multiscale Pore Characteristics of Cement-Based Materials with High-Volume Fly Ash Contents and Different Water-Binder Ratios

Research on Strength Prediction Model of Sand-like Material Based on Nuclear Magnetic Resonance and Fractal Theory

FRACTAL ANALYSIS OF STRESS-DEPENDENT DIFFUSIVITY OF POROUS CEMENTITIOUS MATERIALS

Experimental analysis on the relationship between pore structure and capillary water absorption characteristics of cement‐based materials

Simulation of Porosity Effect on Mechanical and Creep Properties of Cement Paste at Microscale

Simulation Of Porosity Effect On Mechanical And Creep Properties Of Cement

Effect of the entrained air void on strength and interfacial transition zone of air-entrained mortar

Prediction model of the mortar's yield stress based on the aggregate's volume fraction and properties

Research on the strength prediction for pervious concrete based on design porosity and water-to-cement ratio

Quantitative Relationship Between Strength and Porosity of Nano-Silica-Modified Mortar Based on Fractal Theory