Abstract:There is an ongoing debate, in Concrete Science and Engineering, whether cementitious materials can be viewed as poromechanics materials in the sense of the porous media theory. The reason for this debate is that a main part of the porosity of these materials manifests itself at a scale where the water phase cannot be considered as a bulk water phase, but as structural water; in constrast to water in the gel porosity and the capillary porosity. The focus of this paper is two-fold: (1) to review the microstructure of cementitious materials in the light of microporomechanics theory by starting at the scale where physical chemistry meets mechanics, and which became recently accessible to mechanical testing (nanoindentation):(2) to provide estimates of the poroelastic properties (drained and undrained stiffness, Biot coefficient, Biot modulus, Skempton coefficient) of cementitious materials (cement paste, mortar and concrete) by means of advanced homogenization techniques of microporomechanics. This combined experimental-theoretical microporomechanics approach allows us to deliver a blueprint of the elementary poroelastic properties of all cementitious materials, which do not change from one cementitious material to another, but which are intrinsic properties. These properties result from the intrinsic gel porosity of low density and high density C-S-H, which yield a base Biot coefficient of 0.61<b⪯0.71 and a Skempton coefficient ofB=0.20–0.25. While the base Biot coefficient decreases gradually at larger scales, because of the addition of non-porous solid phases (Portlandite,..., aggregates), it is shown that the Skempton coefficient is almost constant over 3–5 orders of magnitude.

Simulation of Porosity Effect on Mechanical and Creep Properties of Cement Paste at Microscale

Simulation Of Porosity Effect On Mechanical And Creep Properties Of Cement

Imperfect Interface Effect on Creep Property of Hardened-Cement Pastes: Investigations from Nano to Micro Scales

Numerical Simulation of High-Strength Concrete Creep under Cyclic Load

Strain-rate Sensitivity of Cement Paste by Microindentation Continuous Stiffness Measurement: Implication to Isotache Approach for Creep Modeling

Association of macroscopic laboratory testing and micromechanics modelling for the evaluation of the poroelastic parameters of a hardened cement paste

Determining Porosity and Pore Network Connectivity of Cement-Based Materials by a Modified Non-Contact Electrical Resistivity Measurement: Experiment and Theory

Strain Rate Effect on Micro-Mechanical Properties and Creep Behavior of Hardened Cement Paste

A new method for predicting compressive strength of cement-based materials

An exploratory experimental and 3D numerical investigation on the effect of porosity on wave propagation in cement paste

Empirical Estimation of Pore Size Distribution in Cement, Mortar, and Concrete

Critical Features of Microstructure Development of Early-Age Cement Paste Revealed by Non-Contact Electrical Resistivity Measurement

Prediction of micro creep behavior of hardened cement paste based on the isotache model of clays

Is concrete a poromechanics materials?—A multiscale investigation of poroelastic properties

Indentation creep of cementitious materials: Experimental investigation from nano to micro length scales

Multiscale Poromechanics of Wet Cement Paste

A Micromechanical Investigation of Cement Paste Through a Combination of the X-ray Computed Tomography and the Phase Field Method

Evaluation of concrete creep properties based on indentation test and multiscale homogenization method

New Insights into Creep and Creep Recovery of Hardened Cement Paste at Micro Scale

Effects of Water-to-cement Ratio and Curing Age on Microscopic Creep and Creep Recovery of Hardened Cement Pastes by Microindentation

Micro-cantilever testing on the short-term creep behaviour of cement paste at micro-scale