Abstract:Ball indentation technique has been studied extensively in literature and it has been widely applied to determine mechanical properties of different materials because of simplicity and minimal requirement of material for the tests. Originally, the material deformation was represented in terms of a representative strain, which is a non-dimensional form of indentation diameter and a representative stress, which again is the instantaneous mean pressure multiplied by some empirical factors. It is known that the state of deformation as well as stress beneath the ball is multiaxial in nature in a ball indentation test. In this work, a new hybrid algorithm for estimation of equivalent stress and equivalent plastic strain during the process of indentation in the most stressed location beneath the ball has been developed. The algorithms uses experimental load–indentation data as well as the multiaxial stress and strain parameters obtained from 2D axisymmetric elastic-plastic finite element simulations. The stress and strain multiaxial parameters are functions of applied load, material yield stress and strain hardening exponents. The algorithm is iterative in nature and uses suitable initial guess values for material yield stress and strain hardening exponents and it converges very quickly. This method can be applied to determine the material stress–strain curve for a wide range of equivalent plastic strain, yield stress as well as plastic strain hardening exponent of the engineering materials. The data points of load vs. indentation depth as obtained directly from the ball indentation tests can be used in the new algorithm without the need for conducting unloading during the test. To illustrate the new scheme, two case studies have been presented where the results from the proposed new method have been compared with those of the existing method in literature and tensile test data to check the accuracy.

A Bayesian inverse approach to measure the anisotropic plasticity properties of materials using spherical indentation experiment

Inverse Method to Determine Parameters for Time-Dependent and Cyclic Plastic Material Behavior from Instrumented Indentation Tests

Identification of plastic properties through spherical indentation

Spherical Indentation into Elastoplastic Materials: Indentation-response Based Definitions of the Representative Strain

Size-dependent sharp indentation-II: a reverse algorithm to identify plastic properties of metallic materials

Determining plastic properties of a material with residual stress by using conical indentation

An Energy-Based Method to Extract Plastic Properties of Metal Materials from Conical Indentation Tests

Spherical indentation method for estimating equibiaxial residual stress and elastic–plastic properties of metals simultaneously

An Inverse Approach to Determine the Mechanical Properties of Elastoplastic Materials Using Indentation Tests

Using spherical indentation to determine creep behavior with considering empirical friction coefficient

Crystal plasticity assessment of the effect of material parameters on contact depth during spherical indentation

A novel method to extract the equi-biaxial residual stress and mechanical properties of metal materials by continuous spherical indentation test

Study of plastically deformed region underneath the ball in indentation tests and evaluation of mechanical properties of materials through finite element simulation and a hybrid algorithm

Determination of elastoplastic properties in anisotropic materials with cubic symmetry by instrumented indentation

Research on Determining Elastic–Plastic Constitutive Parameters of Materials from Load Depth Curves Based on Nanoindentation Technology

Material Characterization Via Neural Network

New sharp indentation method of measuring the elastic–plastic properties of compliant and soft materials using the substrate effect

Material characterization based on dual indenters

Extracting the isotropic uniaxial stress-strain relationship of hyperelastic soft materials based on new nonlinear indentation strain and stress measure

Depth-sensing instrumented indentation with dual sharp indenters: stability analysis and corresponding regularization schemes

Material model calibration through indentation test and stochastic inverse analysis