Strain Localization and Cracking Behavior of Sandstone with Two Gypsum-Infilled Parallel Flaws

Ruide Lei,Zhenyu Zhang,Filippo Berto,P. G. Ranjith,Chengpeng Zhang

DOI: https://doi.org/10.1016/j.tafmec.2020.102873

IF: 4.374

2021-01-01

Theoretical and Applied Fracture Mechanics

Abstract:The infilled flaws within rocks significantly influence the mechanical behavior of non-through flawed rocks. To investigate the influence of infilling on strain localization in the pre-cracking, cracking and cracking coalesce stages, experimental and numerical investigations were conducted on sandstone containing two gypsum-infilled parallel flaws, but of different flaw geometric configurations. The full-field strain evolution and progressive cracking process are analyzed using the acoustic-optical-mechanical methods, while the stress evolution and stress transfer by infilling were studied by the particle flow code modeling. The results show that the major principal strain of flawed sandstone with infilling changes from the diffused ellipse to highly localized linear strip with the increase of loading level, while the shear strain keeps a diffused ellipse shape invariable. The shear strain localization of infillings with a large flaw inclination initiates at a lower loading level than that of small one. The peak strength and Young's modulus of flawed sandstone show a first decrease, then increase and finally decrease trend with the ligament angle increasing from 0 degrees to 150 degrees, and both achieve their minimums at 60 degrees. Ten types of cracks were observed, and four patterns of crack coalescence were identified. By comparison with sandstone of open flaws, the flaw infilling simplifies the geometric pattern of produced crack networks, which is quantitatively characterized by fractal dimension analysis. The numerical modeling shows that the infilling enlarges the compressive bond force zone and decreases the tensile bond force zone in the surrounding areas of pre-existing flaw, thus increasing the reinforcement coefficient. Moreover, the flaw geometric configuration has a significant influence on the reinforcement coefficient. It is also found that the increment of reinforcement co-efficient defined by crack initiation stress is greater than those defined by either crack coalescence or peak stresses.