Abstract:Different from the widely used high-voltage (HV) inductive power transfer (IPT) systems, the low-voltage IPT systems with HV input suffer from the following challenges: the high output current brings high conduction losses in the secondary side, especially at the receiver coil; and the HV conversion ratio, such as 400 V input and 24 V output, results in the difficulties in designing the compensation parameters and loosely coupled transformer. To overcome these issues, a novel IPT topology is proposed in this article by incorporating the series-capacitor full-bridge (SCFB) inverter and inverse coupled current doubler rectifier. Thus, the following three improvements are achieved: first, the voltage stress of three primary switches is reduced to half of the input voltage because of the special series capacitor structure. Second, the inherent one-fourth voltage conversion ratio is achieved and reduced greatly the difficulties in designing the compensation parameters. Third, the current flowing through rectifier circuit is reduced to half of conventional full-bridge rectifier. Furthermore, the LC-LCC compensation is employed for matching the proposed SCFB topology while a novel parameter optimization method is proposed to improve the conversion efficiency. To demonstrate the claimed features of the proposed solution, a 1.2 kW IPT prototype with 400 V input, constant voltage 24 V output is built and tested. The measured efficiency curve indicates that the efficiency from 8 to 50 A load keeps above 94.5% and peaks at 96.63%.

A PS/S Current-Fed IPT System with Variable Capacitors for Achieving ZPA Operation

A Parameter Design Method for High Performance LCLC-LC Compensated CPT Systems

Analysis and Design of an IPT System Based on Shunt Inductor Compensation for Battery Charging Applications.

Minimizing Primary Current Based on Asymmetric Parameter Design Method under Wide Load Range and Variable Coupling Condition in Inductive Power Transfer Systems

A Gyrator-Based Converting-Splitting Method of Designing Inductive Power Transfer Systems with Constant Current and Constant Voltage Charging

An Optimal Variable Frequency Phase Shift Control Strategy for ZVS Operation Within Wide Power Range in IPT Systems

Design of an Inductive Power Transfer System with Constant Current and Constant Voltage Outputs Based on Multi-frequency Circuit

A Novel Two Degrees of Freedom Control Strategy for PS/S Current-fed IPT System

Minimizing Current in Inductive Power Transfer Systems With an Asymmetrical Factor for Misalignment Tolerance and Wide Load Range

Parameter Design Method with All Capacitor Voltage Stresses Optimization of LCLC-LC Compensated CPT System

Compact Z-Impedance Compensation for Inductive Power Transfer and its Capacitance Tuning Method

Compact Capacitive Compensation for Adjustable Load-Independent Output and Zero-Phase-Angle Input for High Efficiency IPT Systems

A Resonant Tank Based Approach for Realizing ZPA in Inductive Power Transfer Systems

An IPT System with Constant Current and Constant Voltage Output Features for EV Charging

A High-Efficiency IPT System With Series-Capacitor Full-Bridge Configuration and Inverse Coupled Current Doubler Rectifier for High-Input, Low-Voltage, and High Output Current Applications

A Circuit Design Method for Constant Voltage Output With Zero Phase Angle and Minimum Coupler Voltages in Capacitive Power Transfer

Power Factor Correction Modulated Wireless Power Transfer System with Series-Series Compensation

A Frequency Tuning Series-Series WPT System with Wide Coupling and Load Ranges

An Optimized Frequency and Phase Shift Control Strategy for Constant Current Charging and Zero Voltage Switching Operation in Series-Series Compensated Wireless Power Transmission

Design of LCC-S Compensation Topology and Optimization of Misalignment Tolerance for Inductive Power Transfer

Enhancing V2G Applications: Analysis and Optimization of a CC/CV Bidirectional IPT System with Wide Range ZVS