Abstract:Structural Health Monitoring, Ahead of Print. Thermal integrity testing has been successfully used to assess the quality of cast-in-place piles for the past decade. It employs temperature data measured during concrete curing to identify defects along the piles' length. However, the uptake of this technology has been rather limited in the piling industry. The main concerns are that the method is not standardised and its reliability is not well understood. In order to address these, there are a number of fundamental questions that need to be explored in more detail, including (a) the optimum time to conduct the assessment, (b) the defect thermal impact, (c) the zone of influence on temperature sensors, (d) the minimum detectable size of a defect and (e) the associated optimum sensor location required. In this paper, experimental and numerical studies were conducted to examine these questions. Fibre optic sensors were employed on model concrete piles in laboratory tests to provide fully distributed temperature data throughout the curing process. The test results showed that the optimum time to assess the defects is approximately at 60% of the time to reach peak temperature and the minimal detectable defect size, using the currently available optical fibre sensor technology, is 4% of the cross-sectional area. In addition, the thermal influence of different defect sizes is presented. Following this, it is shown in the paper that the minimum numbers of sensor cables required to identify defects with cross-sectional areas of 4%, 5% and 8% are eight, six and four cables, respectively. The optimum layout of these sensor cables within a pile cross-section has also been discussed. When specifying pile instrumentation for integrity assessment, the findings of this paper enable practising engineers to make informed judgements in relation to the size of defects they would like to detect (and hence the associated risk this entails) together with the corresponding instrumentation layout required.

Research on Integrity Detection Method for Bored Pile Using Distributed Optical Fiber Temperature Sensing Technology

Thermal integrity profiling of cast-in-situ piles in sand using fiber-optic distributed temperature sensing

Application of Distributed Optical Fiber Sensing to Testing Inner Force of Prefabricated Piles

Application of Distributed Fiber Optic Sensing Techniques in Bored Pile Detection

Pile defect assessment using distributed temperature sensing: fundamental questions examined

Application of Fiber Bragg Grating Sensor in PHC Pipe Pile: Axial Force Test

Multipoint Traveling Wave Decomposition Method and Its Application in Extended Pile Shaft Integrity Test

Experimental Study on BOTDR Temperature Compensation in Bored Pile Detection

Experiment and numerical study on the monitoring of super long cast-in-place pile temperature based on BOTDR technology

BOTDR Monitoring Analysis of Anti-Sliding Pile Internal Force

Application of a Distributed Optical Fiber Sensing Technique in Monitoring the Stress of Precast Piles

Measuring geo-grids stress using distributed fiber-optic sensors based on pulse-prepump-Brillouin optical time domain analysis

Distributed fiber optic sensing along driven ductile piles: Design, sensor installation and monitoring benefits

Model Test on Bearing Characteristic of Static Drill Rooted Energy Pile

Identification of bored pile defects utilizing torsional low strain integrity test: Theoretical basis and numerical analysis

RESEARCH AND APPLICATION OF INTELLIGENT PROCESSING PLAN FOR PILE FOUNDATION DATA DETECTED WITH DISTRIBUTED OPTICAL FIBER

Performance Monitoring of Offshore PHC Pipe Pile Using BOFDA-based Distributed Fiber Optic Sensing System

Fiber Optic Monitoring of an Anti-Slide Pile in a Retrogressive Landslide

Investigation of Less Temperature-Sensitive Fiber Bragg Grating Strain Sensor in Pile Jacking Field Test

Experimental Test of Ground Settlement Measurement Using Distributed Fiber Optic Sensing Technology

Test and Study of Pipe Pile Penetration in Cohesive Soil Using FBG Sensing Technology