Abstract:Piles supporting transmission towers, offshore structures (such as wind turbines), or infrastructures in seismic areas are frequently subjected to either one-way or two-way cyclic lateral loadings. Relatively little attention, however, has been paid to compare and understand the effects of different loading regimes (one-way or two-way cycling) on lateral responses of piles in soft clay. For this reason, a series of field tests in soft clay are carried out to compare one-way and two-way cyclic responses of single piles and of jet-grouting reinforced piles. The field tests reveal that the single pile subjected to two-way cycling experiences much more rapid degradation in lateral stiffness and capacity, but accumulates much smaller residual pile deflection (δ p), than the single pile under one-way cycling. This is because the reverse part of the two-way cycling also generates plastic strain, causing additional softening and strength reduction in the soil surrounding the pile. After each cycling, non-zero bending moment (i.e. locked in moment, or M L) is retained in the single piles, and the M L increases with the δ p. The one-way cycling leads to two times larger M L than the two-way cycling, as it causes greater δ p. The maximum M L in the pile after one-way cycling can be up to 40% of the maximum bending moment induced during the previous cyclic loading stage. After application of jet-grouting surrounding the upper part of the single pile, it greatly reduces degradation of lateral pile stiffness, accumulation of δ p and therefore development of M L. Compared to the field measurements, the API (API RP 2A-WSD, recommended practice for planning, designing, and constructing fixed offshore platform-working stress design, 21st edn. API, Washington, 2000) code underestimates the lateral stiffness of the pile under one-way cycling, while overestimates that of the pile under two-way cycling, leading to a non-conservative prediction of bending moment in the latter pile.

Multipoint Traveling Wave Decomposition Method and Its Application in Extended Pile Shaft Integrity Test

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

STUDY ON PILE LONGITUDINAL VIBRATION CONSIDERING EFFECT OF UNDERGROUND WATER LEVEL

Influence of Weld on Integrity Testing of Prestressed Pipe Piles

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Field Tests of Offshore Driven Piles Subjected to Lateral Monotonic and Cyclic Loads in Soft Clay

Model Tests on the Bearing Capacity of Precast Open-Ended Micro Pipe Piles in Soft Soil

Analytical Study of Employing Low-Strain Lateral Pile Integrity Test on a Defective Extended Pile Shaft

Apparent wave velocity inverse analysis method and its application in dynamic pile testing

Analytical Model for Laterally Loaded Soil-Extended Pile Shaft Applied to Verifying the Applicability of Lateral PS Method

Research on low-strain test method of high-cap pile foundation without eccentric vertical excitation

Lateral vibration characteristics of an extended pile shaft under low-strain integrity test

PS Wave Based Parallel Seismic Test for Pile Length Assessment

Pile Damage Detection Using Machine Learning with the Multipoint Traveling Wave Decomposition Method

Dynamic Soil Reactions Around a Beam-on-Multiple-Piles Structure and Their Application in the Parallel Seismic Integrity Test

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile

Dynamic Response of a Defect Pile in Layered Soil Subjected to Longitudinal Vibration in Parallel Seismic Integrity Testing

Field test and numerical analysis of transversal dynamic characteristics of pile groins due to tidal bores

Field Testing of One-Way and Two-Way Cyclic Lateral Responses of Single and Jet-Grouting Reinforced Piles in Soft Clay

A 3D analytical model for distributed low strain test and parallel seismic test of pipe piles

Theoretical Basis and Numerical Simulation of Parallel Seismic Test for Existing Piles Using Flexural Wave