Abstract:The pill-box window is one of the important components of microwave vacuum electronic devices (VEDs), and research into it is of great significance. As the operating frequency increases, the problems associated with the reduction in the structure size include the reduction of the brazing plane and the reduction in the tolerance of the pill-box window. These problems will cause traditional pill-box windows to be unsuitable in high-frequency bands, especially in terahertz and sub-terahertz regions. The most influential factor is the length of the circular waveguide in the box window. The welding plane of the over-size pill-box window is the annular bottom surface on both sides of the dielectric sheet, which is larger than the circular waveguide, and the operating frequency does not directly affect the area of the brazing surface. Choosing a suitable diameter for the dielectric sheet can effectively increase the tolerance to the length of the pill-box window circular waveguide. Therefore, an over-size pill-box window would be a practicable approach to improve the performance compared to the traditional pillow-box in high-frequency bands. This paper describes, in detail, the theoretical design, simulation optimization and experimental process of this improved pill-box window. An over-size pill-box window suitable for G band VEDs was successfully developed. The experimental result in the 215–225 GHz band is that the maximum transmission loss is −1 dB, and the overall transmission loss is close to −0.5 dB. The overall reflection is less than −11 dB.

Investigation on Symmetric and Asymmetric Broadband Low-Loss W-Band Pillbox Windows

A Broadband Low-Lessw-band Pill-box Window

Experimental Study of an Overmoded V-Band Sapphire Pillbox Window

Over-Size Pill-Box Window for Sub-Terahertz Vacuum Electronic Devices

Low-diffraction EMI-shielding Multiband Optical Window Based on Randomized Metallic Mesh

A Semi-Analytic Numerical Algorithm of Diamond Pillbox Windows for Terahertz Vacuum Electron Device Applications

A Broadband Sapphire Disc Pillbox Window for Terahertz Traveling-Wave Tubes

Scattering Matrix Analysis of a High-Power Pill-Box-type Window Without Ghost Mode

Investigation and Batch Fabrication of G-Band Broad Band and Low Loss Monocrystalline Diamond Window for Vacuum Electron Devices

A New Type Ka Band Pillbox

Investigation and Fabrication of a Low Loss and Wideband Single Crystal Diamond Vacuum Window for W-Band Traveling Wave Tube

Design and Analysis of A Waveguide Window for W-Band Twt

Design of Waveguide Windows for mmWave Components

A Study on a Ka-Band Power Window with Thicker Ceramics

Design and Measurement of a Broadband Beryllium Oxide Window With High Power Handling Capability

Low Loss Sharp Photonic Crystal Waveguide Bends

A Low-Loss Slow Wave SIW Bandpass Filter with Blind Via-Holes Using TGV Technology

A Compact and Broadband Balun Based on Multilayer SIW

A Wideband Multibeam Pillbox Antenna Based on Differentially Fed Leaky-Wave Array

Dual-Layer SIW Multibeam Pillbox Antenna with Reduced Sidelobe Level

Fabrication of High Power Microwave Feed Output Window