Morphology Detection Of Optical Components Based On Hysteresis Nonlinear Compensation System

王芳 Fang Wang,卢庆杰 Qing-jie Lu,庄锦程 Jin-cheng Zhuang,王全召 Quan-zhao Wang,韩森 Sen Han
DOI: https://doi.org/10.3788/gzxb20204906.0612001
IF: 0.6
2020-01-01
ACTA PHOTONICA SINICA
Abstract:In order to reduce the error of phase calculation caused by the hysteresis nonlinear of piezoelectric ceramic actuator in phase-shifting interferometer, a control system for a piezoelectric ceramic actuator is designed. The high precision resistance strain sensor and signal conditioning circuit based on the principle of phase-locked amplification are used to detect the displacement of the piezoelectric ceramic actuator. A polynomial mathematical model is established to describe the hysteresis nonlinearity. And then, a feed-forward open-loop control method is proposed to compensate for the hysteresis nonlinearity. Finally, based on the proposed scheme, a tracking control experiment of the desired trajectory of the piezoelectric ceramic actuator is performed. At the same time, a compensation control system and an interferometer are used to detect the surface morphology of the optical element. The experimental results show that after compensation, the tracking error of the piezoelectric ceramic actuator is between - 0.156 mu m and +0.078 mu m, and the hysteresis nonlinearity is reduced from 10.4 % to 2.4 %, and the surface shape undulated height Root Mean Square (RMS) and Peak Valley (PV) of the optical element measured by the interferometer are changed by 0.795 nm and 3.937 nm respectively. It shows that this system is of great significance for the high-precision shape detection of optical components.
What problem does this paper attempt to address?