Abstract:We demonstrated a new optical fiber modal interferometer (MI) for airflow sensing; the novelty of the proposed structure is that an MI is fabricated based on a piece of HAF, which makes the sensitive MI itself also a hotwire. The interferometer is made by applying arc-discharge tapering and then flame tapering on a 10 mm length high attenuation fiber (HAF, 2 dB/cm) with both ends spliced to a normal single mode fiber. When the diameter of the fiber in the processing region is reduced to about 2 μm, the near-infrared dispersion turning point (DTP) can be observed in the interferometer's transmission spectrum. Due to the absorption of the HAF, the interferometer will have a large temperature increase under the action of a pump laser. At the same time, the spectrum of the interferometer with a DTP is very sensitive to the change in ambient temperature. Since airflow will significantly affect the temperature around the fiber, this thermosensitive interferometer with an integrated heat source is suitable for airflow sensing. Such an airflow sensor sample with a 31.2 mm length was made and pumped by a 980 nm laser with power up to 200 mW. In the comparative experiment with an electrical anemometer, this sensor exhibits a very high air-flow sensitivity of −2.69 nm/(m/s) at a flowrate of about 1.0 m/s. The sensitivity can be further improved by enlarging the waist length, increasing the pump power, etc. The optical anemometer with an extremely high sensitivity and a compact size has the potential to measure a low flowrate in constrained microfluidic channels.

The Theoretical Research and Experimental Fabrication of the Dispersion Turning Point Sensors Realized in Tapered-Microfibers

Tapered Optical Fiber Sensing Technology

Microfiber Optical Sensors: A Review

Temperature Sensors Operating Near The Dispersion Turning Point Of Microfiber Based Two-Mode Fiber

Advances in dispersion turning point enhanced ultrasensitive optical fiber refractive index sensors

Axial strain and temperature sensor based on tapered seven-core fiber operating at dispersion turning point

High Sensitive Refractive Index Sensor Based on Dispersion Turning Point Long-Period Fiber Gratings in Tapered Fiber

High Sensitivity Refractometer Based on Tapering Two-Mode Fiber Embedded Long-Period Fiber Grating

Improvement on Refractive Index Sensing by Exploiting the Tapered Two-Mode Fibers

Axial strain and temperature sensor based on tapered biased four-core fiber operating at dispersion turning point

Dual Self-Growing Polymer Microtips on A Multicore Fiber for Humidity and Temperature Discriminative Sensing

PDMS-Coated S-Tapered Fiber for Highly Sensitive Measurements of Transverse Load and Temperature

Dispersion turning point-enhanced photothermal interferometry gas sensor with an optical microfiber interferometer

S-Tapered Fiber Sensors for Highly Sensitive Measurement of Refractive Index and Axial Strain

Dispersion Turning Attenuation Microfiber for Flowrate Sensing

Temperature Sensing Characteristics Based on Up-Taper and Single Mode–Multimode Fiber Structure

A fiber SPR sensor with high comprehensive evaluation indicator based on core mismatched U-Shaped and tapered arm

Fiber-optic Biosensors Based on Tapered Two-Mode Fibers

Sensitivity-Enhanced RI Sensor Based on Cascaded Microfiber Mach–Zehnder Interferometers Near the Dispersion Turning Point With Vernier Effect

High-sensitivity and Low-Temperature Magnetic Field Sensor Based on Tapered Two-Mode Fiber Interference

Highly Sensitive Directional Torsion Sensor Based on a Helical Panda Fiber Taper