Fault location method for multi-terminal MMC-based MVDC distribution system under DC pole-to-ground fault
Yirun Ji,Zhichang Yuan,Jianfeng Zhao,Jiao Fu,Yue Yi,Yuming Zhao
DOI: https://doi.org/10.1049/cp.2018.1752
2018-01-01
Abstract:With the development and application of modular multilevel converter (MMC) HVDC technology, MMC-based medium-voltage dc (MMC-MVDC) distribution system is gradually attracting the attention of researchers in recent years due to its superior harmonic performance, independent control of the active and reactive power, rapid transient response, large transmission capacity and less DC/AC conversion stages. It is very suitable for the future development of urban power grid. In order to improve the power supply reliability and reduce the power outage time of MMC-MVDC system, it is usually required to operate continuously for a period of time when the dc pole-to-ground short circuit fault occurs. Therefore, small current grounding method is usually used. However, when the pole-to-ground fault occurs, the steady-state fault current is small and the steady-state fault voltage is basically the same in each dc line. It is difficult for the current differential protection to locate and isolate the fault area accurately. In this study, firstly, the dc pole-to-ground short circuit fault path is analysed. Secondly, an active fault location method for multiterminal MMC-MVDC system under dc pole-to-ground fault is proposed by using the dc side capacitors of equipment that is originally connected to the MMC-MVDC system, such as two-level converters and dc solid state transformers (DCSSTs). This method can locate the fault dc line actively without adding external signal injection equipment or switching the system ac side grounding resistance, and can reduce the accuracy requirements for current differential protection equipment. Finally, a three-terminal MMC-MVDC distribution simulation model established on PSCAD/EMTDC validates the proposed fault location method.