Abstract:The goal of the presented investigation was to assess the impact of surface laser modification with the implementation of nickel and chromium on the microstructure and tribological behaviour of grey iron. Surface laser modification consisted of remelting the surface layer with simultaneous implementation of selected elements. In the first variant of treatment only nickel was implemented and in the second one, a combination of nickel with chromium together. This treatment was performed on an agriculture machine part made of grey iron and working in intensive friction conditions. The constituted surface layer was characterized by about 0.45 mm of depth and a 160 mm2 area of the most exposed to wear of the treated part. In the case of both types of variants, the achieved surface layer microstructure was identified as homogenized with small grains. It involved nickel in the first variant of modification and nickel and chromium in the second one. The attained microstructure with nickel addition was characterized by nearly 800 HV0.1 of hardness (a 3.6-fold increase in comparison to its core material). The approximate hardness of 900 HV0.1 was achieved in the case of the microstructure enriched with nickel and chromium (over a 4-fold increase in comparison to the core material). The roughness of the surface after laser modification was reduced (nearly 3-fold) in comparison to the original surface of the part that was characterized by quite substantial coarseness. The wear test showed that Ni and Cr laser coatings increased resistance to abrasive wear resulting from the modification of the microstructure by the formation of martensite and grain fragmentation. Laser modified parts had a 2.5-fold smaller mass loss than untreated parts. Both types of performed variants: with the implementation of nickel and a combination of nickel and chromium gave comparable effects.

Sliding Wear Behavior of Laser Surface Hardened Austempered Ductile Iron

Microstructure and wear behavior of arc-shaped 40CrNiMo steel after laser hardening

Study on ductile iron surface laser cladding austenitic stainless steel coating heat treatment to enhance wear resistance

Investigation on Microstructures and Tribological Characteristic of Laser Remelting Layers

Improving the Wear Properties of AISI4130 Steel Using Laser Surface Hardening Treatment

Microstructure and Soil Wear Resistance of a Grey Cast Iron Alloy Reinforced with Ni and Cr Laser Coatings

Microstructure and Wear Resistance of Ductile Cast Iron Laser Clad with Ni-Ti-Co-C

Investigation on the parameters optimization and sliding wear behaviors under starved lubrication of discrete laser surface hardened 25CrNi2MoV steel

Laser Surface Hardening of Ni-hard White Cast Iron

Crack resistance and wear resistance of laser clad layer on the surface of cast iron

Laser strengthening of air-cooled diesel engine phosphorus cast iron cylinder liner and its friction & wear properties

Structural Characteristics and Sliding Friction Properties of 40CrNiMo Steel after Broadband Laser Hardening

Wear Characteristics of Carbon and Tool Steels Hardened by Combined Laser-Ultrasonic Surface Treatment

Study of the Microstructure and Corrosion Properties of a Ni-Based Alloy Coating Deposited onto the Surface of Ductile Cast Iron Using High-Speed Laser Cladding

Microstructural characteristics, hardness and wear resistance of a typical ferritic/martensitic steel surface-treated by pulsed laser

Analysis of Laser Surface Hardening of GM246 Cast Iron

Experimental Study on the Wear Properties of 42CrMo Steel with Different Microstructures and T15 Laser Cladding

Microstructure stability and high temperature wear behavior of an austenite aging steel coating by laser cladding

Effect of Surface Melting and Chromium Surface Alloying on Wear Behavior of Ductile Iron

Abrasive wear behavior and mechanism of high chromium cast iron

Sliding wear of medium-carbon bainitic/martensitic/austenitic steel treated by short-term low-temperature austempering