Investigation of Slagging Characteristics on Middle and Low Temperature Heat Transfers by Burning High Sodium and Iron Coal

Bo Wei,Wenya Wu,Kunpeng Liu,Jianjiang Wang,Lijuan Chen,Jinrong Ma,Feng Wang,Xian Li,Wenjun Yang,Houzhang Tan
DOI: https://doi.org/10.1080/00102202.2020.1830768
IF: 1.9
2020-01-01
Combustion Science and Technology
Abstract:The severe slagging problems during Zhundong coal combustion caused by the high alkali attracted broad attention. To obtain the characteristics and the formation of the deposits at lower gas temperature when the boiler was burning high sodium and iron content Zhundong coal, the slags were sampled in a 260 t/h medium temperature separation circulation fluidized bed boiler and analyzed by X-Ray Fluorescence (XRF) and X-Ray Diffraction (XRD). The slagging status at the same temperature range of a 350 MW Pi type boiler was used to compare and the results indicated that when the Na2O and Fe(2)O(3)content in coal ash was higher, the serious slagging would occur in reducing atmosphere at lower gas temperature area (539 degrees C-876 degrees C). Almost all of the slag presented maroon. Even the gas temperature only was 539 degrees C, the thickness of the slag was 5.61 mm. Nearly all of the sodium and iron content in slag samples in MTS-CFBB exceeded 5% and greater than 10% in part of the collected slag. The Fe species played a key role in the slagging process in reducing atmosphere for the Fe presented Fe(2+)based compounds with lower melting points, which reacted with the other elements to form the lower temperature eutectics adhered to depositing surface, and then promoted the slagging process.
What problem does this paper attempt to address?