Abstract:Ultra-high-performance concrete (UHPC) is a new type of high-performance cement-based composite. It is widely used in important buildings, bridges, national defense construction, etc. because of its excellent mechanical properties and durability. Freeze thaw and salt erosion damage are one of the main causes of concrete structure failure. The use of UHPC prepared with multi-walled carbon nanotubes (MWCNTs) is an effective method to enhance the durability of concrete structures in complex environments. In this work, the optimal mix proportion based on mechanical properties was obtained by changing the content of MWCNTs and water binder ratio to prepare MWCNTs UHPC. Then, based on the changes in the compressive strength, mass loss rate, and relative dynamic modulus of elasticity (RDME), the damage degree of concrete under different salt erosion during 1500 freeze-thaw (FT) cycles was analyzed. The changes in the micro pore structure were characterized by scanning electron microscope (SEM) and nuclear magnetic resonance (NMR). The test results showed that the optimum mix proportion at the water binder ratio was 0.19 and 0.1% MWCNTs. At this time, the compressive strength was 34.1% higher and the flexural strength was 13.6% higher than when the MWCNTs content was 0. After 1500 salt freezing cycles, the appearance and mass loss of MWCNTs-UHPC prepared according to the best ratio changed little, and the maximum mass loss was 3.18%. The higher the mass fraction of the erosion solution is, the lower the compressive strength and RDME of concrete after FT cycles. The SEM test showed that cracks appeared in the internal structure and gradually increased due to salt freezing damage. However, the microstructure of the concrete was still relatively dense after 1500 salt freezing cycles. The NMR test showed that the salt freezing cycle has a significant influence on the change in the small pores, and the larger the mass fraction of the erosion solution, the smaller the change in the proportion of pores. After 1500 salt freezing cycles, the samples did not fail, which shows that MWCNTs UHPC with a design service life of 150 years has good salt freezing resistance under the coupling effect of salt corrosion and the FT cycle.

Nanoindentation-based Micromechanical Characterisation of Ultra-High-performance Concrete Exposed to Freezing–thawing

Development of Internal Moisture Transfer and Cumulative Residual Strain in Concrete under Freeze-Thaw Cycles

Systematic studies on behaviors of ultra-high performance concrete subject to freezing and thawing cycles combining DIC technology

Investigation of Microstructural Damage in Ultrahigh-Performance Concrete under Freezing-Thawing Action

Experimental Investigation of the Deformational Behavior of the Interfacial Transition Zone (itz) in Concrete During Freezing and Thawing Cycles

Mechanics Behavior of Ultra High Toughness Cementitious Composites after Freezing and Thawing

Experimental Study on the Salt Freezing Durability of Multi-Walled Carbon Nanotube Ultra-High-Performance Concrete

Durability of micro-cracked UHPC subjected to coupled freeze-thaw and chloride salt attacks

High temperature and freeze-thaw study of strengthened concrete with ultra-high-performance concrete

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

Sustainable ultra-high performance concrete with incorporating mineral admixtures: Workability, mechanical property and durability under freeze-thaw cycles

Study on Micro-mesoscale Characterization and Impact Load Mechanical Properties of Ultra-High-Performance Concrete After Sustained Elevated Temperature

Experimental study of the durability properties of ultra-high toughness cementitious composites under freezing and thawing cycles

Study on Freezing-Thawing damage mechanism and evolution model of concrete

Thermal-dependent brittleness effect of ultra-high performance concrete exposed to cryogenic flexural loads by acoustic emission evaluation

Theoretical and Experimental Research of Ultra-High-Performance Concrete Tensile Behaviour Based on Micro-Analysis

Experimental Study on Mechanical Properties and Pore Structure Deterioration of Concrete under Freeze–Thaw Cycles

Microstructure and mechanical behaviour of 3D printed ultra-high performance concrete after elevated temperatures

Experimental research on ductility enhancement of ultra-high performance concrete incorporation with basalt fibre, polypropylene fibre and glass fibre

Flexural fatigue behavior of ultra-high performance concrete under low temperatures

Study on Frost Resistance and Interface Bonding Performance through the Integration of Recycled Brick Powder in Ultra-High-Performance Concrete for Structural Reinforcement