Abstract:This study presents a colloidal synthesis method to produce thermoelectric Cu3SbSe4 nanocrystals with high yield. Pb doping is employed to increase carrier concentration and effective mass, confirmed by experimental studies and theoretical calculations. Additionally, lattice distortions and other intriguing nanostructures are found to significantly reduce thermal conductivity. Consequently, the thermoelectric figure of merit zT is greatly enhanced. Developing cost‐effective and high‐performance thermoelectric (TE) materials to assemble efficient TE devices presents a multitude of challenges and opportunities. Cu3SbSe4 is a promising p‐type TE material based on relatively earth abundant elements. However, the challenge lies in its poor electrical conductivity. Herein, an efficient and scalable solution‐based approach is developed to synthesize high‐quality Cu3SbSe4 nanocrystals doped with Pb at the Sb site. After ligand displacement and annealing treatments, the dried powders are consolidated into dense pellets, and their TE properties are investigated. Pb doping effectively increases the charge carrier concentration, resulting in a significant increase in electrical conductivity, while the Seebeck coefficients remain consistently high. The calculated band structure shows that Pb doping induces band convergence, thereby increasing the effective mass. Furthermore, the large ionic radius of Pb2+ results in the generation of additional point and plane defects and interphases, dramatically enhancing phonon scattering, which significantly decreases the lattice thermal conductivity at high temperatures. Overall, a maximum figure of merit (zTmax) ≈ 0.85 at 653 K is obtained in Cu3Sb0.97Pb0.03Se4. This represents a 1.6‐fold increase compared to the undoped sample and exceeds most doped Cu3SbSe4‐based materials produced by solid‐state, demonstrating advantages of versatility and cost‐effectiveness using a solution‐based technology.

Synergistic modulation of electrical and thermal properties of Cu<sub>1.8</sub>S bulk materials via nanostructuring and band engineering

Enhanced Thermoelectric Properties of MnxCu1.8S Via Tuning Band Structure and Scattering Multiscale Phonons

Nanostructured Bi2-Xcuxs3 Bulk Materials With Enhanced Thermoelectric Performance

Enhancing thermoelectric and mechanical properties of p-type Cu3SbSe4-based materials via embedding nanoscale Sb2Se3

Enhanced thermoelectric properties of Cu1.8S via the introduction of ZnS nanostructures

Enhanced thermoelectric properties of Mn Cu1.8S via tuning band structure and scattering multiscale phonons

Highly Enhanced Thermoelectric and Mechanical Properties of Bi-Sb-Te Compounds by Carrier Modulation and Microstructure Adjustment

Effects of sintering temperature on thermoelectric properties of Cu1.8S bulk materials

Modulation Doping of P-Type Cu12Sb4S13 Toward Improving Thermoelectric Performance

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu1.8S Via Carrier Concentration Regulation and Multiscale Phonon Scattering

Synergetic Modulation of Power Factor and Thermal Conductivity for Cu3SbSe4-based System

Enhancing thermoelectric performance of Cu1.8S by Sb/Sn co-doping and incorporating multiscale defects to scatter heat-carrying phonons

Effect of Cu Concentration on Thermoelectric Properties of Nanostructured P-Type MgAg0.97−xCuxSb0.99

Enhanced performance of thermoelectric nanocomposites based on Cu12Sb4S13 tetrahedrite

Enhanced Thermoelectric Performance of Bi–Se Co-Doped Cu 1.8 S via Carrier Concentration Regulation and Multiscale Phonon Scattering

Enhanced Thermoelectric Properties of Cu3SbSe4 Via Compositing with Nano-Snte

Synergistic modulation of mobility and thermal conductivity in (Bi,Sb)2Te3 towards high thermoelectric performance

Synergistically enhanced thermoelectric properties of Bi2S3 bulk materials via Cu interstitial doping and BiCl3 alloying

Tuning Ag content to achieve high thermoelectric properties of Bi-doped p-type Cu3SbSe4-based materials

Band Engineering Through Pb‐Doping of Nanocrystal Building Blocks to Enhance Thermoelectric Performance in Cu3SbSe4

Enhanced Thermoelectric Performance Through Homogenously Dispersed MnTe Nanoparticles in P-Type Bi0.52Sb1.48Te3 Nanocomposites