Abstract:ABSTRACTDeveloped more than 80 years ago, the design procedure of concrete filled steel tubes (CFST) has several limitations that can still be found in most current international design standards. The two main limitations that present themselves are the lack of ability to achieve material enhancement when using high strength materials and restrictions on the geometry of the steel tube thickness to the overall column diameter. This geometric limitation is placed on the design to ensure that the steel tube remains ‘compact’. In complying with these constraints it is assumed in the design equations that local buckling of the steel tube will not take place before the ultimate global buckling load is achieved.With the introduction of higher strength materials, specifically when dealing with steel, the strength increase leads to the design of sections with increased slenderness. As the section becomes more slender, the ability to maintain the compact section limitations in the design codes becomes increasingly difficult. This paper looks at an experimental study on very thin‐walled steel tubes filled with high‐strength concrete and how localised buckling affects their compressive capacity.Adopting a diameter to thickness ratio of 200, 24 circular tubes were constructed using a high‐strength cold‐formed steel sheet, with yield stresses above 500MPa and filled with 100MPa concrete. Employing both thin‐walled sections and high strength materials, the effects of localised buckling in these composite members when subjected to compression has been studied. The experimental programme explored four main conditions; when both the steel and concrete were loaded and bonded together, when the concrete core inside the CFST was loaded, when the steel tube in the CFST was loaded and when the concrete core without the steel tube was tested.By studying the failure modes of both the concrete and the steel tube when acting compositely and individually, the experimental work shows that there is valid evidence to support the theory that even when using high strength materials in slender sections, confinement to the concrete core is provided. Finally, the results of the experimental work have been compared to the compressive design capacities predicted by current international design codes, showing that these provisions are conservative.

Concrete-Filled Steel Tubular Columns with Internal Confinement by High Strength Steel Spirals

Experimental Investigation on Large-scale Slender FRP-Concrete-Steel Double-Skin Tubular Columns Subjected to Eccentric Compression

Confined Concrete-Filled Tubular Columns

Experimental research on seismic performance of confined concrete filled tubular columns under cyclic loading

Compressive behavior of concrete-filled steel tubular columns with internal high-strength steel spiral confinement

Experimental Study on Axial Compressive Behavior of Concrete-Filled Corrugated Steel Tubular Columns

Axial Compressive Performance of Concrete-Filled Steel Tube Stub Columns with High-Strength Spiral Confined Concrete Core

Concrete-filled Steel Tubes with Reinforcing Bars or Angles under Axial Tension

08.17: Experimental Behaviour of High‐strength Thin‐walled Concrete Filled Steel Tubular Stub Columns

Experimental Studies On The Strength With High Slenderness Ratio Concrete Filled Steel Tubular Columns

Axial compressive performance of spirally reinforced high-strength CFST column

Experimental study of the behavior under axial compression of steel tube confined concrete with a circular hollow section (STCC-CHS)

Experimental Investigation of Special-Shaped Concrete-Filled Square Steel Tube Composite Columns with Steel Hoops under Axial Loads

Experimental behaviour of high performance concrete-filled steel tubular columns

Confinement-based design and behaviour of concrete-filled stiffened steel tubular square slender columns

Experimental Behaviour of Concrete-Filled Stiffened Thin-Walled Steel Tubular Columns

Numerical Study on the Axial Compressive Behavior of Steel-Tube-Confined Concrete-Filled Steel Tubes

Structural Behaviors of Steel Tube-encased Concrete Columns Confined by Bolted Circular Thin Steel Tube

Experimental Behavior of Concrete-Filled Stainless Steel Tubular Columns under Cyclic Lateral Loading

Behaviour of Short and Slender Concrete-Filled Stainless Steel Tubular Columns

Mechanical behavior and design applicability of ultra-high-performance concrete-filled circular steel tubular short columns under axial compression