Abstract:Microstructure control is an important subject in solid-state sintering and plays a crucial role in determining post-sintering material properties, such as strength, toughness and density, to name but a few. The preponderance of existing numerical sintering simulations model the morphology evolution and densification process driven by surface energy minimization by either dilating the particles to be sintered or using the vacancy annihilation model. Here, we develop a novel kinetic Monte Carlo model to model morphology evolution and densification during free sintering. Specifically, we derive analytically a heterogeneous densification rate of the sintering system by considering sintering stress induced mass transport. The densification of the system is achieved by modeling the sintering stress induced mass transfer via applying effective particle displacement and grain boundary migration with an efficient two-step iterative interfacial energy minimization procedure. Coarsening is also considered in the later stages of the simulations. We show that our model can accurately capture the diffusion-induced evolution of particle morphology, including neck formation and growth, as well as realistically reproduce the overall densification of the sintered material. The computationally obtained dynamic density evolution curves for both two-particle sintering and many-particle material sintering are found to be in excellent agreement with the corresponding experimental master sintering curves. Our model can be utilized to control a variety of structural and physical properties of the sintered materials, such as the pore size and final material density.

Effect of Size and Homogeneity of Rigid Inclusions on the Sintering of Composites

Influence of Inclusion Shape on Viscous Sintering

Modelling Effects of Short Fibres on Reinforced Glass Matrix Sintering Behaviour

Size and Interface Effects on Tensile Strength of Polymers with Nano/Micro Particle Inclusions

Densification and Mechanical Properties of Si3N4/SiC Nanocomposite Using Si-Nitrided Si3N4 Powder

Effects of Sintering Method on Density and Microstructure of Particulate Reinforced Copper Matrix Composites

Effects of Particle Size on Deformation Behaviour of Metal Matrix Composites

Influence of the Component Size Ratio on Densification and Magnetic Property of Soft Magnetic Composites

A model for the sintering of spherical particles of different sizes by solid state diffusion

Experimental and numerical studies of the effect of particle size on the deformation behavior of the metal matrix composites

Effects of Content and Size of Al2O3 Particle Dispersion on the Sintering Densification Rate of Y-PSZ/Al2O3 Composites.

Measure of combined effects of morphological parameters of inclusions within composite materials via stochastic homogenization to determine effective mechanical properties

Microstructure evolution and densification behavior of TiC/316L composite powders during cold/warm die compaction and solid-state sintering: 3D particulate scale numerical modelling and experimental validation

Modeling morphology evolution and densification during solid-state sintering via kinetic Monte Carlo simulation

Numerical study on the warm compaction and solid-state sintering of TiC/316L composite powders from particulate scale

The Influence of Inclusions on Mechanical Characteristics of Structural-Heterogeneous Materials (A review)

Influence of Fines and Particle Size Distribution on Density and Performance of Sintered Steel Components

The Overall Response of Composite Materials with Inclusions

Tuning the bulk properties of bidisperse granular mixtures by small amount of fines

Effects of Particle Size on Residual Stresses of Metal Matrix Composites

The Effect of Particle Size Gradation on the Microstructure, Mechanical and Thermal Physical Properties of BN-ZrO2-SiC Composites