Wastewater-nitrogen Removal Using Polylactic Acid/starch As Carbon Source: Optimization of Operating Parameters Using Response Surface Methodology
Yan Guo,Chuanfu Wu,Qunhui Wang,Min Yang,Qiqi Huang,Markus Magep,Tianlong Zheng
DOI: https://doi.org/10.1007/s11783-016-0845-y
IF: 6.048
2016-01-01
Frontiers of Environmental Science & Engineering
Abstract:The use of PLA/starch blends for nitrogen removal was achieved. The influence of different operating parameters on responses was verified using RSM. The conditions for desired responses were successfully optimized simultaneously. Blends material may have a promising application prospect in the future. Nitrogen removal from ammonium-containing wastewater was conducted using polylactic acid (PLA)/starch blends as carbon source and carrier for functional bacteria. The exclusive and interactive influences of operating parameters (i.e., temperature, pH, stirring rate, and PLA-to-starch ratio (PLA proportion)) on nitrification (Y1), denitrification (Y2), and COD release rates (Y3) were investigated through response surface methodology. Experimental results indicated that nitrogen removal could be successfully achieved in the PLA/starch blends through simultaneous nitrification and denitrification. The carbon release rate of the blends was controllable. The sensitivity of Y1, Y2, and Y3 to different operating parameters also differed. The sequence for each response was as follows: for Y1, pH>stirring rate>PLA proportion>temperature; for Y2, pH>PLA proportion>temperature>stirring rate; and for Y3, stirring rate>pH>PLA proportion>temperature. In this study, the following optimum conditions were observed: temperature, 32.0°C; pH 7.7; stirring rate, 200.0 r·min-1; and PLA proportion, 0.4. Under these conditions, Y1, Y2, and Y3 were 134.0 μg-N·g-blend-1·h-1, 160.9 μg-N·g-blend-1·h-1, and 7.6 × 103 μg-O·g-blend-1·h-1, respectively. These results suggested that the PLA/starch blends may be an ideal packing material for nitrogen removal.