Abstract:This study used computational fluid dynamics for low greenhouse effect refrigerant (R-513A) simulation analysis in the two-stage 150 USRT class oil-free centrifugal refrigerant compressor using integrated part load value (IPLV) and internal flow field. The compressor rotor speed and mass flow rate for the IPLV working conditions with various loads were planned using Stage 1 and Stage 2 simulations, respectively. The performance and flow field numerical simulation analyses for the two-stage centrifugal compressor is discussed. This study used Ansys-CFX software for numerical simulation analysis and the conservation form of a 3D steady-state Navier–Stokes equation set with the finite volume discretization method for computation. The computing mode produced better computing efficiency and flexible mesh setting using the k-omega (k-ω) model, which has better computational performance in the near wall boundary layer and low Reynolds number flow field (used as the turbulence model) for simulation. The R-513A refrigerant property setting was calculated using the Soave–Redlich–Kwong gas equation. This study discusses the shaft work, pressure ratio, and isentropic efficiency and also describes the main research findings with the meridional pressure, isentropic efficiency contour maps, and flow field velocity vector diagrams. According to the numerical simulation results, in Stage 1 and Stage 2 simulations, the isentropic efficiency produced the highest numerical results in the 75% load case, which are 88.19% and 89.06%, respectively. The isentropic efficiency decreased to 75.93% and 82.26%, respectively, in the 25% load case. The flow field velocity vector diagram shows that in the 25% load case, there was back-flow field distribution near the impeller shroud. The compressor performance was also analyzed.

Analysis of Performance of Two-Stage Screw Compressor under Various Operating Conditions

Simulation of High Speed Oil-free Twin-screw Compressor in Fuel Cell

Simulation of high speed single screw compressor in fuel cell

Study on Usage Efficiency of Single Screw Compressor's Shaft Power Based on Exergy Analysis Method

Analysis on Two Model Stages of High Specific Speed Centrifugal Compressor

Experimental study and model optimization of thermodynamic performance of a single screw water vapor compressor

Modeling of a Two-Stage Rotary Compressor

A Simulation Method for GM-type Helium Compressors

Performance analysis for a rotary compressor at high speed: experimental study and mathematical modeling

Performance Simulation Analysis of a Novel Dual-piston Two-Stage Carbon Dioxide Linear Compressor

Development of a chamber model considering non-uniform pressure distribution for twin-screw compressors

Performance Assessment of A Two-Stage Reciprocating Air Compressor

Theoretical and Experimental Research on Thermal Dynamic Characteristics of Single-Screw Compressor with a New Composite SLIDE valve

Analysis of the leakage in a water-lubricated twin-screw air compressor

Influence of two-phase suction injection on performances of the scroll refrigeration compressor with a high-temperature shell

Design of A Single-Stage Centrifugal Compressor and Numerical Investigation of Simultaneous Adjustment of Inlet Guide Vanes and Diffuser Vanes

Study on the Selection of Single-Screw Steam Compressors in Industrial Steam Supply

Analysis and Improvement of a Two-Stage Centrifugal Compressor Used in an MW-Level Gas Turbine

Analysis of the Performance of the Compressor

150USRT Class R-513A Refrigerant Two-Stage Centrifugal Compressor Design Point and Separation Point Flow Field Simulation Analysis

Upper-limit of Performance Improvement by Using (quasi) Two-Stage Vapor Compression