Abstract:The dual-cylinder opposed linear compressor (DOLC) contains a couple of symmetrical gas loads on the two sides of the movement components. Because the gas loads are symmetrical, the balanced position of movement components will not be offset by gas force during the operating process, and piston displacement can be detected and controlled more easily. Based on the kinetics and thermodynamics theory, the non-linear gas load of the DOLC was linearized by the Fourier method. The relationship between the supply voltage and displacement is presented. Through air compression experiments, the operation features of the DOLC with different syntonic spring groups were analyzed. The performance of the DOLC was considerably affected by work conditions and the stiffness of syntonic spring groups; the closer the work condition was to the sympathetic vibration, the higher the observed efficiency of the DOLC. A jump, hysteresis, and an unstable phenomenon in the process of voltage regulation occurred around sympathetic vibration conditions. In the process of increasing voltage on a certain discharge pressure condition, the displacement jump phenomenon occurred when the intrinsic frequency approacheds power frequency, causing the discharge pressure to drop synchronously. In the process of decreasing voltage on the lower discharge pressure condition, the displacement shrink phenomenon occurred when the intrinsic frequency approached power frequency. Because sympathetic vibration conditions changed with discharge pressures, a hysteresis district existed between the displacement jump point and shrink point. The DOLC worked unstably on the hysteresis district because the discharge pressure fluctuated between the two values. To make the DOLC work stably on higher efficiency, the intrinsic frequency should be configured to a slightly larger value than the power frequency by setting the syntonic spring groups and the mass of movement components to the ratings on the work conditions. Controlling the power frequency after is needed to adhere to the intrinsic frequency of the variable work conditions.

Performance Simulation Analysis of a Novel Dual-piston Two-Stage Carbon Dioxide Linear Compressor

Operational optimisation of a novel dual-piston linear compressor: Simulation and experiment

Design and Test on Moving-Magnet Linear Compressor

A Novel Oil-free Dual Piston Compressor Driven by a Moving Coil Linear Motor with Capacity Regulation Using R134a

Experimental Investigation and Performance Analysis of a Dual-Cylinder Opposed Linear Compressor

Performance Characteristics Around the TDC of Linear Compressor Based on Whole-Process Simulation

Theoretical and Experimental Investigations on the Piston Offset Characteristics in a Four-Stage DC Linear Compressor Unit for a 1.8 K Hybrid Cryocooler

Resistance Torque Based Variable Duty-Cycle Control Method for A Stage Ii Compressor

Theoretical Analysis on a Novel Two-Stage Compression Transcritical CO2 Dual-Evaporator Refrigeration Cycle with an Ejector

Characteristic analysis and energy efficiency of an oil-free dual-piston linear compressor for household refrigeration with various conditions

Simulation Research on Refrigeration Performance of Piston Compressor with Double Suction Ports

Simulation of Dynamic Characteristics of Moving Magnet Linear Compressor for Refrigerator

Performance testing with RC load approach in linear compressors

Dynamic behavior analysis of a moving coil oil-free linear compressor in refrigeration system

Experimental Investigation on Off-Design Characteristics of R290 Rolling Piston Compressor

Numerical simulation of CO<sub>2</sub> two-stage compression refrigeration system with external intercooler

Some Design Features of Co2 Swing Piston Expander

Force assisted discharge valve for piston compressors

Optimization analysis of linear compressor using R290 for capacity-modulation performance improvement

Experimental Investigation on the Steady-State Performance and Piston Stroke Length Control of A Variable Displacement Wobble Plate Compressor

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation