Abstract:Ni-based wrought superalloys are widely used in the hot section of aircraft gas turbine engines for their capability in retaining strength and resisting creep, fatigue, and oxidation at elevated temperature. With the development of the newer generation turbine disk alloys, it is highly imperative for aircraft engine manufacturers to substantiate the use of the materials by conducting a thorough examination of their mechanical properties. As these components are subjected to elevated temperatures and complex stress state in the service process where time dependent creep is the primary deformation failure mechanism and life-limiting factor for the component, it is of great importance to evaluate the relationship between microstructure, creep behavior and the underlying creep deformation mechanism. Therefore, the main objective of the present research aims at investigating the fundamental relationship between external creep condition and internal creep deformation mechanism in a new wrought superalloy with low stacking fault energy (SFE). In order to study the influences of the loading stress level and temperature on the creep deformation mechanism, stress range of 345-840 MPa and temperature range of 650-815 degrees C were selected to carry out the creep experiment. The results show that two kinds of gamma' with different diameters distributed in the matrix and the larger one began to coarsen when the creep temperature increased to 725 degrees C. Under creep temperature of 650 degrees C, the formation of SF resulted from the shearing of gamma' by dislocations dominated the creep deformation. When the temperature range was raised up to 725-760 degrees C, SF and microtwins were the main microstructures after creep deformation. With further increasing the temperature and load, instead of accommodating only in the gamma', the SF and microtwins penetrated the whole gamma' and matrix area. When the temperature was increased to 815 degrees C, the climb/bypass mechanism controlled the creep process.

Evolution and Structure Characterization of the Carbide and Boride during Creep in A Ni-based Superalloy

B22-P-17Evolution of the MC Carbide in Nickel-base Single Crystal Superalloy Exposing at 950 °C

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

Based on Damage Caused by Microstructure Evolution During Long-Term Thermal Exposure to Analyze and Predict Creep Behavior of Ni-based Single Crystal Superalloy

Creep Residual Life Prediction of a Nickel-Based Single Crystal Superalloy Based on Microstructure Evolution

Effects of Microstructure and Lattice Misfit on Creep Life of Ni-based Single Crystal Superalloy During Long-Term Thermal Exposure

Tensile, Creep Behavior and Microstructure Evolution of an As-Cast Ni-based K417G Polycrystalline Superalloy

In Situ SEM Study of Creep Deformation Behavior of Nickel-Based Single-Crystal Superalloys

Properties and Simulation of Nonisothermal Creep of a Directionally Solidified Superalloy

Effect of Annealing Treatment on Microstructure Evolution and Creep Behavior of a Multiphase Ni3Al-based Superalloy

Influence of composition and precipitation evolution on damage at grain boundaries in a crept polycrystalline Ni-based superalloy

Analysis and Prediction of Non-Isothermal Creep Behavior in Ni-based Single Crystal Superalloy

Microstructure Evolution and Dislocation Mechanism of a Third-Generation Single-Crystal Ni-Based Superalloy during Creep at 1170 °C

Investigation on Microstructure Evolution and Fracture Morphology of Single Crystal Nickel-Base Superalloys under Creep-Fatigue Interaction Loading

A Physically Based Model for Correlating the Microstructural Degradation and Residual Creep Lifetime of a Polycrystalline Ni-based Superalloy

Creep Behavior and Deformation Mechanisms of a Novel Directionally Solidified Ni-base Superalloy at 900 °C

Effect of carbon content on the microstructure and creep properties of a 3rd generation single crystal nickel-base superalloy

Creep Mechanism of A Ni-Co Base Wrought Superalloy

Creep Behavior and Microstructure Evolution of Directionally Solidified Superalloy Ic10 at High Temperature

Study of the Creep Behavior of Nickel-Based Single Crystal Superalloy Micro Specimens with Dimensional Effects

Microstructure evolution and deformation mechanism of a [111]-oriented nickel-based single-crystal superalloy during high-temperature creep