Abstract:Centrifugal spray deposition forming technology, which is used in the preparation process of near-net-forming billets, not only reduces the macroscopic segregation and refines the microstructures of billets but also has the characteristics of a rapid solidification structure. The trajectory, velocity, heat transfer and solidification of metal droplets granulated by the centrifugal force during flight will affect the shape, precision and microstructure of the billet. Therefore, it is necessary to study the dynamics and thermal history of droplets in flight. In this study, a single droplet is taken as the object. Considering the resistance of ambient gas, Newton's second law, classical nucleation theory, Newton's cooling law and the energy conservation equation were used to establish a dynamic model and heat transfer solidification model of liquid metal droplets during flight. The influence of the centrifugal disc speed on the diameter of granulated droplets was analyzed. The variation law of droplet flight trajectory and velocity was explored. The supercooling degree in metal droplet nucleation was quantified, and the influence of droplet diameter, superheat and other factors on heat transfer and solidification was revealed. The results show that the numerical calculation results are basically consistent with the previous research results. The trajectory of the droplet is parabolic during flight. The initial velocity of the droplet, the environmental gas resistance and the convective heat transfer coefficient are positively correlated with the rotating speed of the centrifugal disc; however, the droplet diameter is negatively correlated with the rotating speed of the centrifugal disc. The super cooling degree at the time of droplet nucleation and the flight time required for solidification are negatively correlated with the droplet diameter. Among them, the droplet diameter has a linear relationship with the solidification start time and a quadratic curve relationship with the solidification end time. The effect of superheat on the heat transfer and solidification of droplets is not obvious. The conclusions obtained can provide a theoretical basis for the determination of the preparation process parameters.

Building 3D Parts Based on Metal Droplet Deposition Process

Numerical Simulation and Validation of Metal Micro-droplet Deposition Forming

Numerical and Experimental Investigation of Molten Metal Droplet Deposition Applied to Rapid Prototyping

Experimental Investigation of the Sedimentation Behavior of Metal Droplets in Liquid–liquid Systems

A Numerical Analysis on the Metal Droplets Impacting and Spreading out on the Substrate

Research on the Manufacturing of Electrical Power Fittings Based on Metal Droplet Deposition

Study on Flight Dynamics and Heat Transfer Solidification of Metal Droplets during Centrifugal Spray Deposition Forming Process

Numerical Simulation and Analysis of Metal Fused Coating Forming

Manufacturing of micro thin-walled metal parts by micro-droplet deposition

PRODUCED THREE-DIMENSIONAL METAL PARTS BY ELECTRON BEAM SELECTIVE MELTING

NUMERICAL SIMULATION OF PILEUP PROCESS IN METAL MICRODROPLET DEPOSITION MANUFACTURE

The Fusion Process of Successive Droplets Impinging Onto a Substrate Surface

Microchannels Formed Using Metal Microdroplets

Gas entrapment and pore formation in metal droplet-based 3D printing

Metal droplet printing of tube with high-quality inner surface via helical printing trajectory and soluble support

Influence of Droplet Size and Ejection Frequency on Molten Pool Dynamics and Deposition Morphology in TIG-aided Droplet Deposition Manufacturing

Modeling of Temperature Field Evolution During Multilayered Direct Laser Metal Deposition

A study on the solidification shapes of molten metal droplet impacting at low weber number

Numerical simulation of melt pool size and flow evolution for laser powder bed fusion of powder grade Ti6Al4V

Effect of Processing Parameters on Thermal Phenomena in Direct Laser Metallic Powder Deposition

Ultrasonic vibration micro-jet ejection for metal additive manufacture