Abstract:The hybrid additive manufacturing which involves direct metal deposition and high-speed milling has been considered as an effective process to make high performance products with well surface finish. Research that have been reported indicate that continuous energy sources can lead to intolerable residual stress and distortion even after the parts are processed by machine tools. Therefore, a hybrid additive manufacturing machine tool based on pulse laser wire depositing is established taking advantage of its intensive exposure. The designed work area of the hybrid AM machine tool is 50 mm × 50 mm × 100 mm. On this basis, a set of preliminary experiments are carried out to study the performance of the proposed hybrid AM process. Both the substrate and the wire are stainless steel (SUS304), and the wire diameter is 0.6 mm. Depositing trails were kept by oxide film since shield gas is not used during the deposition. Results show that stabilization of the process has a strong impact on both the surface finish and the microstructure. Moreover, experiment results indicate that wire feeding performance is the critical factor influencing the product performance due to the small weld pool size and the rapid melting and solidifying. Typical macrodefects of the fused welding and the exclusive flaw of additive manufacturing are detected. Microstructures show that column grains less than 1 μm dominate the deposition zone, where the column grains grew in the direction of depositing on the middle layers and along the curvature direction on the top surface. A thin wall about 0.5 mm wide is milled, and the result shows that the surface of the bead is greatly improved and no defects are detected after the thin wall is cut. However, the trapezoid cross section indicates that a further study on cutting is still demanded.

Research on the Manufacturing of Electrical Power Fittings Based on Metal Droplet Deposition

The Additive Manufacturing Process of Electric Power Fittings Fabricated by Metal Droplet Deposition

Impact of Process Parameters on Forming Quality and Deposition Efficiency of Unsupported Rods in Wire Arc Additive Manufacturing

Numerical and Experimental Investigation of Molten Metal Droplet Deposition Applied to Rapid Prototyping

Metal Droplet Deposition: From Foundation to Engineering Manufacturing

Manufacturing of micro thin-walled metal parts by micro-droplet deposition

Research Status of Uniform Metal Droplet Spray for Micro-manufacturing

Building 3D Parts Based on Metal Droplet Deposition Process

Technology Research of Direct Metal Forming Based on Electron Beam

Hybrid Direct Manufacturing Method of Metallic Parts Using Deposition and Micro Continuous Rolling

A Novel Selection Method of Scanning Step for Fabricating Metal Components Based on Micro-Droplet Deposition Manufacture

Ultrasonic vibration micro-jet ejection for metal additive manufacture

Uniform Metal Droplet Produced by Pneumatic Generator with Controlled Spray Process and Analysis of the Droplet Deposition Accuracy

Deposition manufacturing of three-dimensional objects by spraying the metal droplets

A Review on Wire-Fed Directed Energy Deposition Based Metal Additive Manufacturing

Fusions Between Successive Deposition Droplets Impinging on a Moving Substrate Surface

Process Optimization of Surface Morphology and Internal Quality Based on Metal Droplets Horizontal Lapped Deposition

Design and Implementation for Metal Micro-droplet Generation System

Study of Hybrid Additive Manufacturing Based on Pulse Laser Wire Depositing and Milling

Experimental Research of Process Parameters in Metal Droplet Deposition Manufacturing

Development of a New Cold Metal Transfer Arc Additive Die Manufacturing Process