Abstract:Roughness on the metal specimen polished surface will be induced when it yields plastic deform or fatigue damage for its interior microscopic crystal grain slip dislocation,and this is very different when it yields elastic deform.Its specula reflection weakened while scattering reflection reinforced.This paper presented a new technique to determine the elastic-plastic boundary and plastic strains on the surface of metal specimen.The metal specimen subjected uniform tension is projected by Slant incident white-light;loads increase as preseted.These distributions of the brightness can be recorded as real-time images by CCD camera.The following simple method we advanced is used to analysis the image data.According the practical situation,one threshold is chosen.The gray level which is greater that the threshold is defined the bright point.Define BI as the reciprocal value of the number of the bright points.In the experiments,BI keeps stable during the period of elasticity;while the material is yielding,the increase of the surface roughness leads to the stronger ability of the random reflection;and the BI goes down sharply.BI keeps monotone decreasing during the period of plasticity.So BI can be taken as a feature parameter.BI can not only be used as a judgment of the status but also be the measuring of the plasticity.Typical experiments can verify the method.The conclusion matches the traditional correlation method very well.This method can be prospectively applied in the engineering with the merit of simple operation and low environmental condition.This paper also discusses a parameter which is very important to the accuracy of this method.Based on the analysis of the data,a method which is called confidence interval was developed to determine the threshold value.And also find that the better results can be obtained with the little of the confidence interval.

Inquire into the method of measuring elastic modulus of polymer and metal films in bulge test

Study of Elastic Modulus and Yield Strength of Polymer Thin Films Using Atomic Force Microscopy

Measurement of elastic modulus of films by three-point bend test

Measuring elastoplastic properties of thin films on an elastic substrate using sharp indentation

The Mechanical Properties of Electroplated Cu Thin Films Measured by Means of the Bulge Test Technique

Elastic Modulus of Nanoporous Alumina Films Through Bulge Test

Experimental Measurement of Polyethylene Chain Modulus by Scanning Force Microscopy

Magnetic and Electric Bulge-Test Instrument for the Determination of Coupling Mechanical Properties of Functional Free-Standing Films and Flexible Electronics

Measurement of Elastic Modulus and Residual Stress of Diamond Thin Films

Study on elastic modulus of ultra-thin copper films by in-situ SEM-SPM nanoindentation

Measurements of Elastic Modulus and Residual Stress of Nickel Film by Microbridge Testing Methods

Novel scanning electron microscope bulge test technique integrated with loading function.

Characterization Method of Thick Films Using the Bulge Test Technique

Study of mechanical-magnetic and electromagnetic properties of PZT/Ni film systems by a novel bulge technique

A New Method of Measuring the Plastic Deformation

Measuring The Elastic Modulus And Ultimate Strength Of Low-K Dielectric Materials By Means Of The Bulge Test

Novel technique for mechanical characterization of thin polymeric tissue membrane

Extraction Of Elastic Modulus And Hardness Of The Soft Metallic Films On Hard Substrates By Nanoindentation

Current Status and Prospects of Bulge Experiments for Thin Film Behavior Testing

Young's modulus determination of soft metal thin films by nanoindentation technique based on the constant modulus assumption analysis

Measuring Thin Film Elastic Modulus Using A Micromachined Cantilever Bending Test by Nanoindenter