Abstract:ZrB2-SiC-Zr2Al4C5 multi-phase ceramics with uniform structure and high density were successfully prepared through the introduction of in situ synthesized Zr2Al4C5 into ZrB2-SiC ceramic via SPS at 1800 °C. A systematic analysis and discussion of the experimental results and proposed mechanisms were carried out to demonstrate the composition-dependent sintering properties, mechanical properties and oxidation behavior. The results showed that the in situ synthesized Zr2Al4C5 could be evenly distributed in the ZrB2-SiC ceramic matrix and inhibited the growth of ZrB2 grains, which played a positive role in the sintering densification of the composite ceramics. With increasing Zr2Al4C5 content, the Vickers hardness and Young's modulus of composite ceramics gradually decreased. The fracture toughness showed a trend that first increased and then decreased, and was increased by about 30% compared with ZrB2-SiC ceramics. The major phases resulting from the oxidation of samples were ZrO2, ZrSiO4, aluminosilicate and SiO2 glass. With increasing Zr2Al4C5 content, the oxidative weight showed a trend that first increased then decreased; the composite ceramic with 30 vol.% Zr2Al4C5 showed the smallest oxidative weight gain. We believe that the presence of Zr2Al4C5 results in the formation of Al2O3 during the oxidation process, subsequently resulting in a lowering of the viscosity of the glassy silica scale, which in turn intensifies the oxidation of the composite ceramics. This would also increase oxygen permeation through the scale, adversely affecting the oxidation resistance of the composites with high Zr2Al4C5 content.

Effect of Al Content in an Al/Si Layer on the Oxidation Behavior of the Mo/Si–Al/Si Double-Layer Coated C/C Composites at 1370 °C

Formation and Oxidation Behavior of Mo-Si-B Composite Coatings with B-rich Interlayer Prepared by Slurry Sintering Method

Effect of Mo/Si Ratio on the Microstructure and Oxidation Resistance of Si-Mo Coating for C/C Composites

Microstructure and oxidation behavior of SiOC coatings on C/C composites co-deposited with HMDS and TEOS by using CVD process

Oxidation Behavior of (Mo,Hf)Si2-Al2O3 Coating on Mo-Based Alloy at Elevated Temperature

Effect of WSi2 content on oxidation behavior of MoSi2-20 vol% Al2O3 composites

Preparation of MoSi2-modified HfB2-SiC ultra high temperature ceramic anti-oxidation coatings by liquid phase sintering

Effect of Al2O3 addition on the microstructure and oxidation behavior of SiC coating prepared by pack cementation on C/C composites

Synthesis and properties of MoAlB composites reinforced with SiC particles

Effect of Si Content on Deposition and High-Temperature Oxidation of Al-Si Coatings Obtained by Magnetron Sputtering PVD Method

High temperature oxidation behavior of MoSi2–Al2O3 composite coating on TZM alloy

Oxidation Resistance and Heat Transfer Simulation of MoSi2-based Coatings on Carbon Fiber Reinforced C-Al2O3 Aerogel Composite

Fabrication and oxidation resistance of mullite/yttrium silicate multilayer coatings on C/SiC composites

Microstructures and performances of pressureless sintered MoSi2-Al2O3 composites

Study on the oxidation mechanism of Al-SiC composite at elevated temperature

Initial damage behavior of Al2O3‐modified SiCf/SiC–B4C composites after oxidation under wet atmosphere at 1200°C

Design and preparation of LiAlSiO4-Al2O3 coating for the oxidation resistance improvement of SiC ceramics

Effect of Si solution in α-Mo on oxidation behavior of Mo-Si-B alloy and oxidation kinetics model

The Effect of MoAlB Substitutions on the Oxidation Behavior of ZrB2-SiC Composites at 1600°C

Effect of Zr2Al4C5 Content on the Mechanical Properties and Oxidation Behavior of ZrB2-SiC-Zr2Al4C5 Ceramics

Effect of Si Content and Temperature on Oxidation Resistance of Fe-Si Alloys