Abstract:Thermal control device based on thermochromis plays an important role in spacecrafts thermal management by automatically adjusting its radiative properities in response to large temperature gradients. The thermal management ability was determined by the device surface radiation performance. During the sun shadow, it is required to dissipate heat as little as possible from spacecraft, which is a low emittance device. While, it desired the device emittance is large enough to meet the heat dissipation requirement facing with the direct sunlight. As a type thermochromic material, La1 - x Sr x MnO3 (LSMO) has obtained broad attention because it showed a considerable superiority in saving energy consumption in space thermal management. It can hold the heat at low temperature due to its low emittance behavior, whereas dissipate the excess heat at high temperature for its high emittance properties. In this work, we prepared the La1 - x Sr x MnO3 ( x= 0125, 0.175, and 0.2) nanoparticles by sol-gel method from the precursors such as lanthanum nitrate hexahydrate, strontium nitrate and manganese nitrate solution (50%). LSMO nanoparticles were dispersed homogeneously in a solution of resins. The mixture then was spin-coated on the clean Al substrates. After standing for 10 h, the coating was cured at 120°C. The structure, morphology, and composition analysis of LSMO nanoparticles or coatings were investigated by X-ray diffraction technique, scanning electron microscopy, and the energy dispersive X-ray spectroscopy, respectively. The total hemispherical emittance of coating was measured by calortmetric method, which test sample was suspended in the center of a liquid nitrogen thermostat. According to the input power, sample temperature, and thermostat temperature, the emittance can be indirectly obtained. Two resins, which is the acrylic resin and the solution of terpineol and ethyl cellulose respectively, was considered to investigated the effect of reslin type on the emittance of coatings. The result of X-ray diffraction shows a single perovskite structure for LSMO nanoparticles at different Sr doped level. A fined LSMO nanoparticle with 50–300 nm, which is detected using scanning electron microscopy, can be obtained by control sol-gel process. The composition analysis results show a comparable stoichiometric ratio. The two resins coating show a different surface morphology, which is more compact in acrylic resin than in the terpineol. Experimental results show that the variation amplitude of coating emittance is 0.45 within the temperature range of 173–370 K. For the acrylic resin coating, the emittance changes from 0.42 at 173 K to 0.85 at 370 K, and it rises from 0.39 at 173 K to 0.83 at 370 K in terpineol resin coating.

Variable Emittance Behavior of Smart Radiative Coating

Thermal Radiative Properties Of(La,Sr)Mno3 Thermochromic Coating Prepared By Sol-Gel Process

Total Hemispherical Emittance of Low Temperature Curing Thermochromic Coatings

Research on Reducing Infrared Emissivity of 8YSZ Coating by Regulating Microstructure

Exploring the Mechanism of Infrared Emissivity Control in YSZ-based Ceramics Doped with Yb2O3

Effect of YSZ Composite Ceramics with Different LaF3 Doping Content on Microstructure Evolution and Infrared Emissivity

Investigation of the Infrared Radiation Characteristics Modulation Mechanism of Titanium Dioxide Composite Yttria-Stabilized Zirconia Ceramics

Thermal Expansion and Thermal Conductivity of SmxZr1−xO2−x/2 (0.1 ≤ X ≤ 0.5) Ceramics

Effects of calcination treatments on phases and properties of (La0.2Nd0.2Sm0.2Eu0.2Gd0.2)2Zr2O7/YSZ mixture, and of pressure on photoluminescence emission of calcined mixture

Influence of ytterbium- and samarium-oxides codoping on structure and thermal conductivity of zirconate ceramics

Monitoring Constrained Sintering of YSZ Coatings Using Fluorescence Spectroscopy and Micro-Hardness

Study on Sintering Behavior of Reaction-Cured Glass Coating

Study of microstructure, electronic structure and thermal properties of Al2O3-doped tetragonal YSZ coatings

Variable Emissivity Property of Magnetron Sputtering Thermochromic Film

High temperature stability and sintering resistance of Gd2O3-Yb2O3-Y2O3-ZrO2 (GYYZO) coating

Thermal Conductivity of Ytterbia-Stabilized Zirconia

A New Route For Sol-Gel High Refractive Index Zro2 Coating

Emissivity of La1-xSrxMnO3/acrylic Resin Thermal Control Coating

Investigating the mechanism of infrared emissivity control in MgO doped YSZ based ceramics

Estimation of La1-xSrxMnO3 (x=0.15~0.5) emittance by thermal irradiation theory

X-ray Photoelectron Spectroscopy Analysis of Scandia-Ceria-Stabilized Zirconia Composites with Different Transport Properties