Abstract:Thermal control device based on thermochromis plays an important role in spacecrafts thermal management by automatically adjusting its radiative properities in response to large temperature gradients. The thermal management ability was determined by the device surface radiation performance. During the sun shadow, it is required to dissipate heat as little as possible from spacecraft, which is a low emittance device. While, it desired the device emittance is large enough to meet the heat dissipation requirement facing with the direct sunlight. As a type thermochromic material, La1 - x Sr x MnO3 (LSMO) has obtained broad attention because it showed a considerable superiority in saving energy consumption in space thermal management. It can hold the heat at low temperature due to its low emittance behavior, whereas dissipate the excess heat at high temperature for its high emittance properties. In this work, we prepared the La1 - x Sr x MnO3 ( x= 0125, 0.175, and 0.2) nanoparticles by sol-gel method from the precursors such as lanthanum nitrate hexahydrate, strontium nitrate and manganese nitrate solution (50%). LSMO nanoparticles were dispersed homogeneously in a solution of resins. The mixture then was spin-coated on the clean Al substrates. After standing for 10 h, the coating was cured at 120°C. The structure, morphology, and composition analysis of LSMO nanoparticles or coatings were investigated by X-ray diffraction technique, scanning electron microscopy, and the energy dispersive X-ray spectroscopy, respectively. The total hemispherical emittance of coating was measured by calortmetric method, which test sample was suspended in the center of a liquid nitrogen thermostat. According to the input power, sample temperature, and thermostat temperature, the emittance can be indirectly obtained. Two resins, which is the acrylic resin and the solution of terpineol and ethyl cellulose respectively, was considered to investigated the effect of reslin type on the emittance of coatings. The result of X-ray diffraction shows a single perovskite structure for LSMO nanoparticles at different Sr doped level. A fined LSMO nanoparticle with 50–300 nm, which is detected using scanning electron microscopy, can be obtained by control sol-gel process. The composition analysis results show a comparable stoichiometric ratio. The two resins coating show a different surface morphology, which is more compact in acrylic resin than in the terpineol. Experimental results show that the variation amplitude of coating emittance is 0.45 within the temperature range of 173–370 K. For the acrylic resin coating, the emittance changes from 0.42 at 173 K to 0.85 at 370 K, and it rises from 0.39 at 173 K to 0.83 at 370 K in terpineol resin coating.

Thermal Radiative Properties Of(La,Sr)Mno3 Thermochromic Coating Prepared By Sol-Gel Process

Preparation, Characterization, And Thermophysical Properties Of (La0.95sr0.05)(2)Ce2o6.95 Ceramic For Thermal Barrier Coatings

Variable Emittance Behavior of Smart Radiative Coating

Improvement of Electromagnetic Properties at Room Temperature in La0.625Ca0.375-Sr MnO3:Ag0.2 (x = 0.09–0.15) Ceramics by Sr Doping

Polycrystalline La0.845Sr0.155MnO3:Ag ceramics (0 ≤ x ≤ 0.5) with room-temperature TCR and MR for improved uncooling photoelectric and magnetic devices

Total Hemispherical Emittance of Low Temperature Curing Thermochromic Coatings

Emissivity of La1-xSrxMnO3/acrylic Resin Thermal Control Coating

Superior La0.67K0.33-Sr MnO3 films with room-temperature TCR prepared by spin coating method

The Thermochromic Properties of La1−xSrxMnO3 Compounds

The Electrical Resistivity and Thermal Infrared Properties of La1−xSrxMnO3 Compounds

La0.67(Ca0.24Sr0.09)MnO3:xAg2O (0 ≤ X ≤ 0.25) Composites with Improved Room–temperature TCR and MR for Advanced Uncooling Infrared Bolometers and Magnetic Sensors

Fabrication of Polycrystalline La-0.67(Sr1-Xcdx)(0.33)Mno3 Thin Films on Si(100) Substrates by Sol-Gel Process

Refined Sr ion ratio to improve room-temperature TCR of La1-xSrxMnO3 (0.175 ≤ x ≤ 0.235) polycrystalline ceramics

Effect of nanostructure on thermoelectric properties of La$_{0.7}$Sr$_{0.3}$MnO$_{3}$ in 300-600 K range

Obtained Large Room-Temperature TCR of La0.67Ca0.25Sr0.08MnO3 Ceramics by Optimizing Sintering Temperature

Emissivity and Optical Properties of Thermochromic Material La 0.7 Ca 0.3− X Sr X MnO 3 (0 ≤ X ≤ 0.3)

Changing the Ca2+ ion ratio to modulate the temperature coefficient of resistivity (TCR) of La1-Ca MnO3 films prepared by the sol-gel spin coating method

Temperature-dependent Emissivity Property in La0.7Sr0.3MnO3 Films

Fabrication of La0.8na0.2mn1-Xcuxo3 (X=0, 0.05) Thin Films on Ysz Substrates Via Chemical Solution Deposition

Estimation of La1-xSrxMnO3 (x=0.15~0.5) emittance by thermal irradiation theory

TCR and MR room-temperature enhancing mechanism of La0.7K0.3−Sr MnO3 ceramics for uncooling infrared bolometers and magnetic sensor devices