Abstract:The cutters on the cutterhead of a tunnel boring machine (TBM) are usually divided into center cutters, face cutters, and gage cutters, and have significantly different force characteristics. In this study, the authors conduct a series of full-scale cutter rotary cutting tests to compare the differences in the cutter force, the morphology of rock ships, and the efficiency of rock breaking. The results indicate that with increasing cutter spacing, the influence exerted by the cutters on one another in terms of their performance at breaking rocks decreases and their normal force gradually increases, while the rolling force of the cutters is less influenced by the spacing between them. The ratio of the normal force to the rolling force of the gage cutter is less than that of the face cutter, indicating a lower efficiency of breaking rock of the gage cutter. The ratio of rock chips with larger size (>50 mm) and smaller size (<10 mm) gradually decreases while that of rock chips with medium size (about 10–50 mm) gradually increases with increasing installation angle, such that the distribution of the particle size becomes more uniform. Excessive or insufficient penetration rate (PR) will increase the proportion of small rock chips, and a moderate PR will produce rock chips with a larger characteristic size and a more uniform size distribution. Then, a three-dimensional rock-breaking model by all cutters of actual TBM cutterhead is established based on the particle flow method. The results of the simulations indicate that the force on the inner ring of the center cutter is greater than that on the outer ring, and an increase in the installation radius weakens the load difference between the two rings. The normal and rolling forces of face cutters gradually increase, while their side force first increases and then decreases. The side force of the gage cutter significantly increases with the installation angle.

Wear Characteristics of TBM Disc Cutter Ring Sliding Against Different Types of Rock

Experimental Study on Partial Wear of TBM Disc Cutter

Experimental investigation on wear behaviors of TBM disc cutter ring with different cooling methods

Experimental Investigation on the Influence Factors on TBM Cutter Wear Based on Composite Abrasion Test

Analytical Research on the Wear Mechanism of TBM Disc Cutters Based on an Energy Approach

The energy method to predict disc cutter wear extent for hard rock TBMs

Research on Numerical Simulation of Rock Breaking Using Tbm Disc Cutters Based on Udec Method

Theoretical and Applied Research of the Deformation of the Continuous Cutterhead of TBM

Experimental study of the wear behavior of tunnel boring machine disc cutter ring under Fe-based coatings

Analysis on the Rock–Cutter Interaction Mechanism During the TBM Tunneling Process

Rock Adaptability of TBM Variable Cross-section Cutter Ring Based on Finite Element Simulation

Wear and abnormal fracture failure mechanisms of alloy teeth in TBM insert tooth disc cutters

Evaluation of TBM Cutter Wear in Granite and Developing a Cutter Life Prediction Model for Face Cutters Based on Field Data: A Case Study

Research on Rock-Breaking Characteristics of Cutters and Matching of Cutter Spacing and Penetration for Tunnel Boring Machine

Design of Disc Cutter Wear Test System and Research on Wear Law Based on Eddy Current Testing Technology

Experimental and numerical investigations on the force characteristics of cutter in different regions of the TBM cutterhead

Experimental study on the influence of cutter shape on cutter wear for hard rocks

Effects of Driving Parameters on TBM Dynamic Response and Cracking of the Disc Cutter Ring: A Case Study

Effect of Spatial Variability on Disc Cutters Failure During TBM Tunneling in Hard Rock

A Wear Rule and Cutter Life Prediction Model of a 20-in. TBM Cutter for Granite: A Case Study of a Water Conveyance Tunnel in China

Effect of Impact-Sliding Angle on the Wear Performance of the H13 Steel of a Tunnel Boring Machine Cutter