Abstract:Heat-transfer coefficients (HTC) on surfaces exposed to convection environments are often measured by transient techniques such as thermochromic liquid crystal (TLC) or infrared thermography. In these techniques, the surface temperature is measured as a function of time, and that measurement is used with the exact solution for unsteady, zero-dimensional (0-D) or one-dimensional (1-D) heat conduction into a solid to calculate the local HTC. When using the 0-D or 1-D exact solutions, the transient techniques assume the HTC and the free-stream or bulk temperature characterizing the convection environment to be constants in addition to assuming the conduction into the solid to be 0-D or 1-D. In this study, computational fluid dynamics (CFD) conjugate analyses were performed to examine the errors that might be invoked by these assumptions for a problem, where the free-stream/bulk temperature and the heat-transfer coefficient vary appreciably along the surface and where conduction into the solid may not be 0-D or 1-D. The problem selected to assess these errors is flow and heat transfer in a channel lined with a staggered array of pin fins. This conjugate study uses three-dimensional (3-D) unsteady Reynolds-averaged Navier–Stokes (RANS) closed by the shear-stress transport (SST) turbulence model for the gas phase (wall functions not used) and the Fourier law for the solid phase. The errors in the transient techniques are assessed by comparing the HTC predicted by the time-accurate conjugate CFD with those predicted by the 0-D and 1-D exact solutions, where the surface temperatures needed by the exact solutions are taken from the time-accurate conjugate CFD solution. Results obtained show that the use of the 1-D exact solution for the semi-infinite wall to give reasonably accurate “transient” HTC (less than 5% relative error). Transient techniques that use the 0-D exact solution for the pin fins were found to produce large errors (up to 160% relative error) because the HTC varies appreciably about each pin fin. This study also showed that HTC measured by transient techniques could differ considerably from the HTC obtained under steady-state conditions with isothermal walls.

Determination of Local Heat Transfer Coefficient Based on Bulk Mean Temperature Using a Transient Liquid Crystals Technique

Determining mainstream reference temperature using the non-dimensional temperature analysis in the transient liquid crystal technique

Simultaneous Determination of Reference Free-Stream Temperature and Convective Heat Transfer Coefficient

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Quantification of Heat Transfer Coefficient in Transient Liquid Crystal Experiments

INVESTIGATION OF A QUASI-STEADY LIQUID CRYSTAL TECHNIQUE FOR FILM COOLING HEAT TRANSFER MEASUREMENTS

Three-Dimensional Transient Heat Conduction Equation Solution for Accurate Determination of Heat Transfer Coefficient

Determination of Local Bulk Temperature Based Heat Transfer Coefficient in the Channel with Multiple Inlets and Multiple Outlets

Uncertainties of the Transient Thermochromic Liquid Crystal Method in Gas Turbine Internal Cooling Measurements

Time-accurate CFD conjugate analysis of transient measurements of the heat-transfer coefficient in a channel with pin fins

Evaluation of Heat Conduction and Visualization of Heat Flux in a Plate Making Use of Heat Transfer Experiments

Research on Transient Measurement of Heat Transfer Coefficient Distribution with Liquid Crystal Technique

Local Heat Transfer Measurements in Narrow Impingement Channel by Transient Liquid Crystal Technique

A Method For Processing Transient Heat Transfer Measurements In The Presence Of Nonuniform Initial Wall Temperature

Application of transient liquid crystal on internal cooling research of gas turbine airfoil

Improved Liquid-Crystal Thermometry Excluding Human Color Sensation

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental Investigation of Heat Transfer Characteristics on Turbine Endwall with Full Coverage Film Cooling

Comparison of Heat Transfer Measurement Techniques on a Transonic Turbine Blade Tip

Internal Heat Transfer Experiment with Liquid Crystal Transient Technique in Contraction Channel with Jet

Measurements Of Surface Temperature And Heat Transfer Using A Fluorescence Imaging System Based On Thermographic Phosphors

Heat Transfer Investigation in A Smooth Rotating Channel with Thermography Liquid Crystal